User manual MIELE KWL 4712 S ED

[. . . ] Operating and installation instructions Wine storage unit KWL 4712 S ed KWL 4912 S ed To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 813 570 Contents Description of the appliance . 11 Switching off for longer periods of time . 12 The optimum temperature and humidity . [. . . ] The temperature display will continue to flash until the set temperature has been reached or the door has been shut again. The display then lights up constantly. Door alarm The alarm will sound if the door is left open for more than approx. 3 minutes. 18 Defrosting Condensate and frost can build up on the back wall of the appliance whilst it is in use. These are automatically removed and defrosted by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance. Ensure that the condensate channel and drain hole are never blocked so that condensate can flow away without hindrance. 19 Cleaning and care Before cleaning Never use cleaning agents containing abrasive substances such as sand, soda, acids or chemical solvents. "Non-abrasive" cleaning agents are also unsuitable as they can cause matt areas to appear. Stainless steel surfaces can be treated using a conditioning agent for stainless steel such as Neoblank (available for the Miele UK Spare Parts Department). Follow the manufacturer's instructions on the label. Make sure that no water can penetrate into the electronic unit or into the lighting. Do not let water get into the drainage channel and drain hole when cleaning. Do not use steam cleaning apparatus to clean the appliance. Steam could reach the electrical components and cause a short circuit. The data plate located inside the appliance must not be removed. It contains information which is required in the event of a service call. ^ Switch the appliance off at the wall socket and remove the plug. shelves, for cleaning. Cleaning the outer casing, the interior and accessories Use warm water with a little washing up liquid. Accessories and shelves should all be hand-washed only. ^ Clean the condensate channel and drain hole frequently, so that condensate can drain away unhindered. Use a straw or similar to clear the drain if necessary. ^ Clean stainless steel surfaces with a suitable cleaning agent following the manufacturer's instructions on the packaging. ^ After cleaning, wipe the interior and accessories with a damp cloth, and dry with a soft cloth. [. . . ] ^ Raise the door, open it outwards and remove it carefully. Unscrew the lower hinge bracket c and refit lower hinge bracket b on the opposite side. ^ Remove cover cap e from underneath the door and and pull hinge pin f out from underneath the other side of the door. ^ Now insert hinge pin f in the bearing bush on the opposite side of 31 ^ Place the door on upper hinge pin i. [. . . ]