User manual MIELE KWT4974SGED

[. . . ] Operating and installation instructions Wine conditioning unit KWT 4974 SG ed To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. GW M. -Nr. 06 846 510 Contents Description of the appliance . 10 Switching off for longer periods of time . 11 The optimum temperature and humidity . [. . . ] To unlock the appliance, carry out the procedure in the reverse order, turning the key in the opposite direction. 18 Alarm Your appliance is fitted with a warning system which ensures that the temperature in the three zones cannot rise or fall unnoticed and impair the wine. Activating the alarm system The alarm system is always active. It does not have to be switched on manually. Temperature alarm The alarm will sound if the temperature in one of the zones rises approx. The relevant temperature display will flash at the same time. The alarm will sound and the temperature display will flash: ­ when you switch the appliance on, and for as long as the temperature in a particular zone differs from the temperature set. ­ if the door has been left open for a while in order to re-arrange or take wine bottles out and warm air has entered the appliance. ­ if a large number of wine bottles are put into the storage unit at once. ­ if there has been a lengthy interruption to the power supply. Switching the alarm off early Once the set temperature has been reached in a particular temperature zone, the alarm stops and the temperature display concerned lights up constantly. However, if the noise disturbs you, you can switch the alarm off before this if you wish. ^ Press the alarm off button concerned. The temperature display continues to flash until the set temperature has been reached. The display then lights up constantly, The alarm system is now fully active once more. Door alarm If the door has been left open for more than approx. 60 seconds the alarm will sound. 19 Defrosting Condensate and frost can build up on the back wall of the appliance whilst it is in use. These are automatically defrosted and removed by the appliance. The condensate is drained away via a channel and drain hole into an evaporation system at the back of the appliance. Ensure that the condensate channel and drain hole are never blocked so that condensate can flow away without hindrance. 20 Cleaning and care Before cleaning Never use cleaning agents containing abrasive substances such as sand, soda, acids or chemical solvents. "Non-abrasive" cleaning agents are also unsuitable as they can cause matt areas to appear. Stainless steel surfaces can be treated using a conditioning agent for stainless steel such as Neoblank (available for the Miele UK Spare Parts Department). Follow the manufacturer's instructions on the packaging. Make sure that no water can penetrate into the electronic unit or into the lighting. Do not let water get into the drainage channel and drain hole when cleaning. Do not use steam cleaning apparatus to clean the appliance. Steam could reach the electrical components and cause a short circuit. The data plate located inside the appliance must not be removed. [. . . ] ^ Refit brackets l and m as well as cover n turned through 180° on the opposite side. ^ Screw hinge bracket j into the opposite side. ^ Unscrew screw a out of lower hinge bracket b. 32 , We recommend that the changing of the door hinging is carried out by a qualified kitchen fitter. It is essential that the procedure is carried out by two people. [. . . ]