User manual MIELE MLT 4601 INSTALLATION MANUAL

[. . . ] Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. [. . . ] Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flambè under the range hood; risk of fire · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period. Clean the hood using a damp cloth and a neutral liquid detergent. Should you wish to change the front panel mounted on the hood for the accessory panel provided, proceed as follows: · Remove the three screws fastening the front panel to the sliding carriage. Replace the new front panel, using the screws removed as above. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. By simply closing the sliding panel all the functions are switched off. SWITCH L M Light Motor FUNCTIONS Switches the lighting system on and off Switches the extractor motor on and off 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. Medium speed, suitable for most operating conditions, thanks to an optimum relation between hood performance and noise. Maximum speed, suitable when the highest cooking vapour emission has to be eliminated for longer periods. The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. Wash the filters, taking care not to bend them. When refitting the filters, make sure that the handle is visible on the outside. [. . . ] Remove the filters one at a time holding them up with one hand and pulling the handle downwards with the other hand at the same time. Wash the filters, taking care not to bend them. When refitting the filters, make sure that the handle is visible on the outside. These filters are not washable and cannot be regenerated, and must be replaced approximately every four months or more frequently by particularly heavy use. [. . . ]