User manual MIELE NOVOTRONIC T230C

[. . . ] Operating instructions for condenser tumble dryer T 230 C To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed or used for the first time. 14 B Load the drum and switch on the dryer . 31 Transporting the machine to its installation site . 34 If you no longer wish to use an external condensed water outlet . [. . . ] If the dryer is used frequently then clean the condenser unit after approx. Removing the condenser unit ^ Turn the lever on the inner cover downwards to the vertical position. ^ Pull the cover forwards ^ Then remove it by pulling it diagonally upwards. ^ Open the service panel by pressing the two lower corners at the same time (see illustration). The hooks at the side will prevent the panel from falling off. ^ Now the remove the panel by pulling it diagonally upwards. ^ Turn the lever on the condenser unit to the vertical position. Com manuals search engine Cleaning and care If you cannot see any fluff: ^ Replace the condenser unit (see following page). If you can see some fluff: ^ Clean the condenser unit as described below. Cleaning the condenser unit ^ When rinsing the condenser unit, make sure you position it as shown in the next two illustrations. ^ Pull the condenser unit out of its housing by the handle. Checking the condenser unit ^ Use a shower head or similar to rinse the unit out as shown. ^ Hold the condenser unit up to the light as shown. ^ Check to see if there is any fluff inside it. The arrows in the illustration above indicate where to look. Com manuals search engine Cleaning and care Replacing the condenser unit ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove. ^ Replace the cover making sure the hooks locate correctly. hold it at an angle and push it gently downwards. ^ Then turn the lever upwards into the horizontal position to lock the cover. ^ Replace the service panel and press the upper edge until it clicks into position. [. . . ] €“ If the Drying indicator lamp is not on, the increased drying level is deactivated. €“ If the Drying indicator lamp is flashing, the increased drying level is activated. F Pressing the Start button switches between activating and deactivating increased drying. G Switch the machine off with the I-On / 0-Off button. [. . . ]