User manual MIELE QUICK GUIDE ROTARY IRON QUICK GUIDE

[. . . ] The higher the temperature the more permanent the result of ironing. The temperature selector is used to set the ironing temperature. The individual temperature range is distinguished by dot symbols. [. . . ] If during the ironing process you lose power, press the black heater plate release button to remove the item. A special feature of the rotary iron is the finger guard. If your fingers touch the heater plate, the roller stops rotating and the heater plate lifts off. Yes, ironing covers are available from your nearest Miele Dealer or Miele Service Department. How much space do I need to store the iron?When folded away the iron requires a minimum of floor space 2. 4 square feet. The four rollers allow the iron to be easily moved. B890-9-00 Tablecloths Iron the middle first to avoid creases. · Lay the tablecloth crossways so that the ends hang over to the right and left. · Iron the un-ironed section on both sides using the left-hand side of the roller. · Let the ironed middle section hang over the left end of the roller so that no crease is produced. · After folding, iron again if necessary. Sheets and bedspreads Sheets may be ironed like tablecloths, or if a lengthwise fold is acceptable, fold the sheet together lengthwise and iron it on both sides. Duvet covers · Button the duvet cover. Start the first run by carefully feeding in the closed button strip on the left side of the roller. To iron without a fold: · Iron one side of the duvet cover, flip over, and iron on the other side. If folds are acceptable: · Fold the duvet cover lengthwise and iron from left and right. Pillow cases · First iron the fastened button strip (as with duvet covers) · Then iron the whole pillow case on both sides Trousers · Crease the trousers and lay on the roller. The area from the waistband to the crotch should hang down over the left-hand edge of the roller. · Cover the crease with a damp cloth then turn the roller by hand until the part of the trousers to be ironed is covered by the heater plate, and iron. · Iron each crease from both sides in this manner. Shirts Remove feed board before ironing shirts!Sleeves and cuffs · Smooth out the sleeve and lay it on the roller. [. . . ] Front sides · Lay the front on to the left-hand end of the roller, iron from the bottom hem up to the armhole so that the unironed part of the back can be ironed. · Now move the shirt out and iron past the armhole to the collar. · Iron the right hand side, but inside out. [. . . ]