User manual MIELE S 318 I

[. . . ] Operating instructions Vacuum cleaner S 300i - S 318i To prevent accidents and machine damage, read these instructions before installation and use. UV M. -Nr. 05 907 720 Contents IMPORTANT SAFETY INSTRUCTIONS . 26 Where to purchase new dustbags and filters . 26 When to replace the dustbag and filters . [. . . ] Le tuyau d'aspiration et le tube télescopique renferment des fils électriques. Les prises mâles ne doivent pas se trouver en contact avec de l'eau. Ces éléments peuvent être nettoyés seulement avec un tissu sec et non humide. L'humidité constitue un risque de choc électrique. Nettoyez l'aspirateur seulement avec un tissu sec ou légèrement humide lorsqu'il est débranché. Cet appareil est muni d'un enrouleur de cordon automatique. Tenez la fiche lorsque vous rembobinez le cordon d'alimentation et ne la laissez pas fouetter le plancher. Ne procédez pas à des réparations à l'exception de celles précisées dans la section "Entretien". Toute autre réparation devrait être effectuée par un technicien autorisé. Le fabricant ne peut être tenu responsable de réparations effectuées par un technicien non autorisé. Mise au rebut d'un vieil appareil Avant de jeter un vieil aspirateur au rebut, veuillez couper le cordon d'alimentation et rendre la fiche inutilisable. Assurez-vous que l'appareil ne constitue aucun danger pour les enfants avant de le ranger en vue de le jeter. CONSERVEZ CES INSTRUCTIONS. 11 Guide to the machine 12 Guide to the machine 1 Power cord 2 Park-System 3 Cord rewind switch 4 Suction power selector (depending on model)* 5 Thermo indicator * 6 On / Off switch 7 Exhaust filter * 8 Blower connection socket 9 Dustbag change indicator 10 Release button for accessories compartment 11 Handpiece 12 Air inlet valve 13 Locking button 14 Telescopic wand * 15 Elbow 16 Dust compartment lid release 17 Telescopic wand release button * 18 Dust compartment filter (motor protection) 19 Dust bag 20 Electrobrush socket * 21 Floor brush * 22 Carrying handle 23 Wand bracket Features marked * depend on the model and may vary or not be available on your model. Some models are supplied with a Miele Electrobrush or Turbobrush as standard (not illustrated). See the Operating Instructions supplied with these brushes for more information. 13 Before using the vacuum cleaner Attaching the suction hose ^ Slide open the dust compartment shutter (depending on model). The dust compartment shutter is designed for clean handling and prevents dust and odors from escaping. If you remove the suction hose from the vacuum cleaner for storage close the dust compartment shutter before putting it away. ^ Insert the elbow into the suction socket. Removing the suction hose ^ Press the release buttons on the side of the elbow and lift the hose from the socket. 14 Before using the vacuum cleaner Connecting the suction hose and the telescopic wand ^ Fit the handpiece of the suction hose firmly into the suction wand. Turn the handpiece and wand in opposite directions until they lock with a click. ^ To release the handpiece from the telescopic wand press the locking button (see arrow) and pull apart. Adjusting the telescopic wand (select models) Once one section of the telescopic wand is inside the other the height can be adjusted for comfortable vacuum cleaning. ^ Press the telescopic wand release button (see arrow) to release the tubes and adjust the height. Note: When a resistance is felt it has reached its maximum length. Do not force it beyond this length! Connecting the suction wand sections (select models) Both sections of the telescopic wand have locating arrows. When connecting the tubes, ensure that the two arrows point to each other. 15 Before using the vacuum cleaner Attaching the floor brush (select models) ^ Insert the telescopic wand into the floor brush and turn in either direction until it locks with a click. ^ To release the floor brush from the telescopic wand, press the locking button (see arrow) and pull the wand out of the floor brush. [. . . ] Turn off the vacuum cleaner using the On/Off switch. Unwind the full length of the power cord. Allow the vacuum to cool down for 30 minutes. 31 Technical Service In the event of a fault which you cannot correct, please contact the Miele Technical Service Department. U V 1-800-999-1360 techserv@mieleusa. com 1-800-565-6435 service@miele. ca 32 Optional accessories Turbobrush (standard or optional accessory) The Turbobrush is intended for cleaning short to medium pile carpeting. [. . . ]