User manual MIELE S2180 ATLANTIS

[. . . ] Operating Instructions Vacuum Cleaner S 2000 To prevent accidents and machine damage, read these instructions before installation and use. 23 When to change the thread catcher on the standard floor brush . 29 3 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGTo reduce the risk of fire, electric shock or injury: Before Using ~ To reduce the risk of electric shock, ~ Check the voltage rating of the vacuum cleaner before connecting the power cord to an electrical outlet. Your power source should correspond with the voltage rating plate located on the underside of the vacuum. [. . . ] Connecting the floor brush ^ Place the floor brush into a the suction hose and twist until it clicks into place. ^ To separate the parts b, press the locking button. Adjusting the floor brush c For vacuuming carpets and rugs, lower the tool by: ^ pressing the foot switch marked ö. For cleaning smooth floors, raise the tool by: ^ pressing the foot switch marked ä. For safety, when vacuuming stairs it is best to start at the bottom and move upwards. 12 Included accessories The following accessories are included: a Dust brush with natural bristles b Upholstery tool c Crevice nozzle d Accessory clip for the included accessories Position the accessories as indicated. Accessory clip ^ Press onto the elbow until it clicks into place. Floor brush Parquet-3 (depending on model) Special brush with natural bristles intended for cleaning parquet and laminate floors, especially those susceptible to scratching. The parquet floor brush can be cleaned with the vacuum cleaner using the crevice nozzle if necessary. 13 Use Power cord , Unwind the cord completely to aid the vacuum in dissipating heat. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Keep the cord away from heated surfaces. This appliance is equipped with a power cord reel. Hold the plug when rewinding onto cord reel. Do not allow plug to whip when rewinding. Unwinding ^ Hold the plug and pull a out the power cord. , To reduce the risk of electric shock, the vacuum has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, contact a qualified electrician. Rewinding ^ Unplug the vacuum from the outlet. ^ Press the rewind switch - the power cord will rewind automatically b. Hold the plug so that it does not whip around when rewinding. [. . . ] The temperature limiter automatically turns the vacuum off. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust. A heavily soiled exhaust or dust compartment filter can also be the cause of overheating. Turn the vacuum off and pull the plug from the outlet. [. . . ]