User manual MIELE S4000-VACUUM CLEANER

[. . . ] Operating instructions Vacuum cleaner S 4000 To prevent accidents and machine damage, read these instructions before installation and use. UV M. -Nr. 06 579 361 Contents IMPORTANT SAFETY INSTRUCTIONS . 22 Purchasing new dustbags and filters . 26 Replacing the "SUPER air clean" filter . [. . . ] ^ Press ­ to turn the vacuum cleaner on at the lowest power level. ^ Press + to turn the vacuum cleaner on at the highest power level. Every push of a button on the radio handpiece is displayed by the indicator light. The vacuum can still be used if the battery in the radio handpiece is weak or not inserted at all. ^ Turn the vacuum on with the foot switch. The vacuum will operate continuously on the maximum suction power. ^ Turn the vacuum off with the foot switch. 17 Operation While vacuuming The vacuum cleaner can also stand on its end for vacuuming stairs, drapes etc. , To prevent static electricity your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when vacuuming fine dust, flour or sawdust as these materials are more likely to create a static discharge. To further prevent static discharge while vacuuming, pull the vacuum along by the hose with one hand while continuing to hold the handpiece in the other hand. Adjusting the suction The symbols on the controls indicate what each setting is suitable for. a b c d e f curtains, lightweight fabrics upholstery, cushions thick pile carpets, rugs and runners energy-saving, daily use lightly soiled textured carpets textured hard flooring, and intensive cleaning of carpets 18 Operation The controls vary from model to model, and are described as follows. Rotary selector ^ Turn the rotary selector to the desired suction power setting. + / ­ controls Press the controls until the light bar above the desired suction power setting is illuminated. ^ Press the + control to select a higher setting. ^ Press the ­ control to select a lower setting. + / ­ at the radio handpiece Press the controls until the desired suction power is shown in the vacuum display on the canister. ^ Press the + control to select a higher setting. ^ Press the ­ control to select a lower setting. Every push of a button at the handpiece is displayed by the indicator light. 19 Operation Opening the air inlet valve (not available in models with radio handpiece) The air inlet valve is designed to provide a quick, convenient reduction of suction power, e. g. when moving from a carpet to an area rug. ^ Open the air inlet valve far enough to reduce the power. Opening the air inlet valve reduces the power to the tool being used. 20 Transport and storage Park-System A Park-System has been designed to conveniently park the telescopic wand at the vacuum cleaner during pauses. ^ A special parking attachment is fitted to all floor brushes. Insert the lower clip of the floor brush into the slot on the end of the vacuum cleaner from above. Transport and storage ^ For easier transportation and storage ­ stand the vacuum cleaner vertically. ­ insert both clips of the floor brush into the two point holder on the side of the vacuum. ­ insert one part of the telescopic wand into the other (depending on model). 21 Maintenance and care , Turn off the vacuum and unplug it from the outlet before performing any maintenance work. [. . . ] Allow the vacuum to cool down for 30 minutes. After sales service In the event of a problem that you can not fix yourself, please contact the Miele Service Department. 33 Optional accessories Each model may be accessorized with one or several of the following tools. Electrobrush SAB 100-3 The rechargeable battery brush is intended for intensive cleaning and restoring of thick pile carpeting. It is particularly suitable for cleaning and restoring crushed carpet pile of floor coverings subject to hard wear, especially in high traffic areas. [. . . ]