User manual MIELE S 4210 S IRIUS DELUXE, MIDS IZE CANIS TER OPERATING MANUAL

[. . . ] Operating instructions Vacuum cleaner S 4000 en - US, CA To prevent accidents and machine damage, read these instructions before installation and use. 07 126 390 Contents IMPORTANT SAFETY INSTRUCTIONS. 22 Purchasing new dustbags and filters . 26 Replacing the "SUPER air clean" filter . [. . . ] ^ Press the rewind switch again to stop the rewinding. ^ Hold the plug so that it does not whip around when rewinding. Turning the vacuum on and off ^ Press the On/Off switch. 16 Operation Models with radio frequency controls The operating state is shown by the Standby indicator on the vacuum. The vacuum can be switched to a standby mode during pauses. ^ Press the Standby button on the handpiece. To turn the vacuum on again: ^ Press the Standby button on the handpiece. The vacuum cleaner turns on to the last selected power level. ^ Press ­ to turn the vacuum cleaner on at the lowest power level. ^ Press + to turn the vacuum cleaner on at the highest power level. Every push of a button on the radio handpiece is displayed by the indicator light. The vacuum can still be used if the battery in the radio handpiece is weak or not inserted at all. ^ Turn the vacuum on with the foot switch. The vacuum will operate continuously on the maximum suction power. ^ Turn the vacuum off with the foot switch. Only use the Standby mode for short pauses during vacuuming. Do not leave the vacuum in Standby mode, there is a danger of overheating and damage. 17 Operation While vacuuming The vacuum cleaner can also stand on its end for vacuuming stairs, drapes etc. , To prevent static electricity your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when vacuuming fine dust, flour or sawdust as these materials are more likely to create a static discharge. To further prevent static discharge while vacuuming, pull the vacuum along by the hose with one hand while continuing to hold the handpiece in the other hand. Adjusting the suction The symbols on the controls indicate what each setting is suitable for. a b c ( e f curtains, lightweight fabrics upholstery, cushions thick pile carpets, rugs and runners energy-saving, daily use lightly soiled textured carpets textured hard flooring, and intensive cleaning of carpets 18 Operation The controls vary from model to model, and are described as follows. Rotary selector ^ Turn the rotary selector to the desired suction power setting. + / ­ controls Press the controls until the light bar above the desired suction power setting is illuminated. ^ Press the + control to select a higher setting. ^ Press the ­ control to select a lower setting. + / ­ at the radio handpiece Press the controls until the desired suction power is shown in the vacuum display on the canister. ^ Press the + control to select a higher setting. ^ Press the ­ control to select a lower setting. [. . . ] A heavily soiled exhaust or dust compartment filter can also be the cause of overheating. Turn off the vacuum cleaner using the On/Off switch. Unwind the full length of the power cord. Allow the vacuum to cool down for 30 minutes. [. . . ]