User manual MIELE T 234 C

[. . . ] Operating instructions for condenser tumble dryer T 234 C To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 465 690 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children. [. . . ] ^ Pull the condenser unit out of its housing by the handle. Checking the condenser unit ^ Use a shower head or similar to rinse the unit out as shown. ^ Hold the condenser unit up to the light as shown. ^ Check to see if there is any fluff inside it. The arrows in the illustration above indicate where to look. 20 Cleaning and care Replacing the condenser unit ^ With the handle facing upwards, push the condenser unit back into position in its housing. ^ Turn the lever down to the horizontal position, making sure that the hook on the lever clicks into the groove. When replacing the inner cover after cleaning, ensure that the rubber seal fits correctly into the groove. ^ Replace the inner cover making sure the hooks locate correctly. Hold it at an angle and push it gently downwards. ^ Then turn the lever upwards into the horizontal position to lock the cover. ^ Replace the service panel and press the upper edge until it clicks into position. ^ Then flush the unit through from the front. ^ Check the condenser unit again for any visible fluff and if necessary flush it through again until it has all gone. ^ Remove any soiling still visible inside the housing unit by hand using a damp cloth. Do not try and access areas you cannot reach by hand!^ Also make sure the rubber seals are clean. The rubber seals must not be removed and must be free of kinks. , It is important to ensure that both the condenser unit and the cover are correctly positioned and locked otherwise water may leak from the machine. 21 Problem solving guide With the help of the following notes minor faults in the performance of the machine, some of which may result from incorrect operation, can be put right without contacting the Service Department. , Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work. General problems Problem Possible cause The tumble dryer fails to No obvious cause. Remedy ­ Have you followed the switch-on procedure correctly (see "How to dry correctly")?­ Is the plug correctly inserted in the socket and switched on?­ Has the fuse or circuit breaker tripped?Static charge can be reduced by adding a fabric conditioner to the final rinse in the washing machine or a fabric conditioner sheet to the load in the dryer. Items made of synthetic Synthetic fibres tend to fibres are charged with attract static charge. static electricity after drying. 22 Problem solving guide Problem There is a build up of fluff. [. . . ] E Turn the programme selector to Minimum iron - Normal. F Pressing the Start button alters the drying level. ­ If the Drying indicator lamp is flashing: the standard drying level is Normal+ ­ If the Drying indicator lamp is not flashing, the increased drying level is not activated and the drying level will remain on the standard setting ( ). G Switch the machine off with the I-On/0-Off button. [. . . ]