User manual MIELE T 9246 C

[. . . ] Operating instructions for condenser tumble dryer T 9246 C To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. G M. -Nr. 06 731 710 Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children. [. . . ] * Weight of dry laundry 22 Changing the programme sequence Changing a programme while it Interrupting a programme is running ^ Switch the dryer off. You cannot change to another programme once a programme has started (this prevents unintentional alterations). If an attempt is made to change a selection, Option not possible will appear in the display. It is still possible to select or deselect the Anti-crease and Buzzer Extra options. You will need to cancel the current programme before you can select a new one. To continue drying ^ Switch the dryer on. The programme will continue, as long as the cooling down phase has not been reached. Adding or removing laundry after a programme has started ^ Press the Door button. ^ Open the door. , Do not touch the back of the drum when adding or removing items. The drum could be very hot danger of burning. To continue drying ^ Press the Start/Stop button. Cancelling a programme ^ Press the Start/Stop button. The items will be cooled down, depending on the temperature reached and how long they have been dried for. If you press the Start/Stop button again during the cooling down phase, Finish will appear in the display. ^ Switch the dryer off and then on again. ^ You can now select a different programme. Note The time remaining shown in the display may now vary from the actual drying time. 23 Cleaning and care Emptying the condensed water container The condensed water will be collected in the condensed water container unless the appliance has been fitted with a drain hose (see "Installation"). Empty the condensed water container after every drying programme. Please empty the container will appear in the display if the maximum level of the condensed water container is reached. The message will go out when the dryer is switched off and then back on again. ^ Empty the container. ^ Replace the container in the dryer. , Condensed water should not be consumed. It could lead to health problems for people and animals. Condensed water can be put to household use (e. g. To ensure that any residual particles of fluff in the condensed water are removed before use, pass it through a fine sieve or paper filter first. , Close the door fully. Otherwise the door and the front panel of the condensed water container could suffer damage when pulling the container out. ^ Pull out the container. ^ Hold it at the front and towards the back and keep it in a horizontal position when carrying it. 24 Cleaning and care Cleaning the fluff filters The fluff which is created by the drying process is collected by the fluff filters in the door and the door opening. Clean the filters after each drying programme*. Cleaning them whilst dry Tip: You can also use a vacuum cleaner to remove the fluff. [. . . ] When the code has been activated, you have to enter a code after switching the dryer on. Otherwise the dryer cannot be operated. Lock code . . . 250 ^ Press the Start/Stop button to confirm the code. The following will appear in the display: Lock code activated Once the machine is switched off, it can only be used again if the code is entered. [. . . ]