User manual MIELE T 9820

[. . . ] Operating and Installation Instructions Gas Dryer T 9820 To prevent accidents and machine damage read these instructions before installation or use. en - US, CA M. -Nr. 06 640 602 2 , WARNING For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death. ­ Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. ­ WHAT TO DO IF YOU SMELL GAS ß Do not try to light any appliance. ß Do not touch any electrical switch. ß Do not use any phone in your building. [. . . ] The fault cannot be ­ Check the possible faults as described above. ­ Open and close the door to turn off the indicator. If the problem persists call Technical Service. The dryer is making a thumping or grinding sound. The sound is caused by ­ To determine if the noise is due to airflow, temporarily remove the exhaust duct from the the high airflow rate in machine. If the noise lessens, the ductwork is the the ducting of the dryer. Rigid or flexible aluminum This is not a fault. ducting is the best option for reducing the noise. If the problem persists please contact Technical Service. 22 Frequently asked questions The program is canceled. Possible fault Solution This is not a fault. ­ The indicator goes out by opening and closing the door. The electronic has detected that there is no ­ Single items should be dried with the laundry in the drum and "45 min. warm" program, if necessary use the cancels the program. Single items or already dried laundry can also cause a program stop. The "Rotary iron" or "Hand iron" indicator flashes. The fault cannot be ­ The indicator goes out by opening and closing detected immediately. If the problem persists call Technical Service. The laundry is pressed on the door and below the door. The restriction insert in the ­ Reinsert the restriction insert in the vent opening. Removing it may result in poor drying results, vent opening at the rear of damage to the laundry and higher CO2 the dryer was removed. emissions. 23 After sales service Repairs In the event of a fault which you cannot fix yourself, please contact the service number on the back of this manual. When contacting Technical Service, please quote the model and serial number of your appliance. [. . . ] ­ Non-metallic flexible hose should not be used. ­ For best drying results avoid extra long ducting with too many bends, angles or tight corners. ­ The shorter the exhaust ductwork, the more efficient the dryer will be. Expelled air is slowed down in the ducts due to friction against the inner walls. [. . . ]