User manual MIELE T1036

[. . . ] 14 Cleaning the exterior and the control panel. 15 Emptying the condensed water container . 30 2 IMPORTANT SAFETY INSTRUCTIONS , WARNING - To reduce the risk of Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in these operating instructions. Repairs to electrical appliances should only be performed by qualified personnel. [. . . ] If a fault occurred, a "FAULT" indicator will light. See "Frequently asked questions" for details. ^ Press the "Door" button. ^ Clean the lint filter after each use (see "Dryer care"). ^ Close the door. ^ Press the "On/Off" button to turn off the dryer. ^ Empty the condensed water container weekly (if not connected to a drain). 11 Using the dryer Canceling or changing a program ^ Press and release the "Start/Stop T" button to stop the drying program. To continue drying: ^ Select the new program by pressing the e or - button. ^ Select a dryness level (available in the "Normal" and "Wrinkle-free" programs). ^ Press and release the "Start/Stop T" button to start the new program. Adding or removing laundry during a program ^ Turn off the dryer using the "On/Off" button. ^ Open the door. , CAUTION - Do not touch the rear of the drum while adding or removing items!There is a danger of burns due to high temperatures in the drum. ^ Add or remove items. ^ Turn the dryer back on with the "On/Off" button. 12 Child lock Child lock When activated, the child lock prevents the dryer from being operated by locking the control panel functions. For items which require ironing. To prevent moisture loss, roll up the laundry until ready to iron. Wrinkle-free Available drying options Turbo, Gentle, Anti-crease More Dry Normal Less Dry Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine drying. Program for reducing creasing in delicate items. Individual items to be freshened and fluffed with cool air. Individual items or very small loads, e. g. Take items out immediately after the end of the program while still slightly damp. Allow items to air dry. Smooth Sturdy Fluff - TIMED CYCLES 20 min 30 min Available drying options Gentle, Anti-crease - Dryer care Cleaning the condenser , To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. ^ Clean the condenser every 6 months. Removing the condenser The access panel to the condenser is located on the lower left corner of the dryer. ^ Turn the condenser door lock down and remove the door. ^ Turn the condenser lock up. ^ Press on the lower corners of the access panel and lower it down. ^ Remove the panel up and out of the condenser access area. ^ Pull out the condenser. 17 Dryer care Rinsing the condenser Returning the Condenser ^ Put the condenser back in place in the reverse order. Check that the gasket around the front of the condenser is flush and not crimped. ^ To prevent leaks, make certain the condenser is pushed in all the way and locked in place. ^ Restore power. ^ Rinse the condenser along the left side with warm water. ^ Rinse the condenser from the front with warm water. ^ Check the condenser for visible soiling. [. . . ] This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING ­ Improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the appliance is properly grounded. [. . . ]