User manual MIELE T 9800 VENT ED DRYER OPERATING AND INSTALLATION MANUAL

[. . . ] Vented Dryer T 9800 To prevent accidents and machine damage read these instructions before installation or use. en - US, CA M. -Nr. 06 640 592 Contents IMPORTANT SAFETY INSTRUCTIONS. 13 Adding/removing laundry during a drying program . 16 Cleaning the exterior and the control panel . [. . . ] To ensure proper performance, the dryer is equipped with a safety feature to prevent it from operating when there is an insufficient electrical supply. The machine will automatically shut itself down to avoid risks due to decreased performance and airflow levels. Once a sufficient electrical supply is restored to the machine it will automatically reactivate and can be used as normal. The items dried have static cling Add fabric softener to laundry when washing. Press the "Start/ Stop" button to begin the drying program. Make sure the dryer is plugged in or reset the circuit breaker. Close the door properly. 19 Frequently asked questions The laundry is not dry enough. Possible fault The load contained too many dissimilar items (size and fabrics. ) Solution ­ Continue drying using the "Warm air" program. ­ Select a suitable program. The laundry is still wet. Check if the gas shut-off valve is closed. The light turns off automatically (energy saving). Close and open the door, the light should come on. See "Dryer Care". The program runs too long or stops. Important: To fix the following problems, open and close the dryer door. The exhaust hose or the connection is clogged with lint. Open a window or door to increase air flow. wall vent duct, louvered wall vent, bends, etc. ) regularly for air permeability. Regard the maximum load size per program. ­ Open the zippers of the laundry before drying. If the problem persists, dry items with long zippers using the "45 min. warm" program, if necessary use the laundry basket. The laundry was not spun sufficiently in the washer. Metallic zippers prevent a correct measurement of the laundry's residual moisture. 20 Quick Guide Remove this guide for easy reference To prevent accidents and machine damage read these instructions before installation or use. Quick Guide 1. [. . . ] Flexible foil ducting may move and bounce due to the high airflow of the dryer. This could lead to a thumping or grinding noise. ­ Non-metallic flexible hose should not be used. ­ For best drying results avoid extra long ducting with too many bends, angles or tight corners. [. . . ]