User manual MIELE VACUUM CLEANER S227 LIGHT GRAY S227 KARMINE RED

[. . . ] 25 Removing threads or hair wrapped around the roller . 29 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNINGTo reduce the risk of fire, electric shock or injury: A damaged vacuum cleaner can be dangerous. Check the packaging, the vacuum cleaner and accessories for any signs of damage. If the appliance is not working as it should, has been dropped, damaged, left outdoors or immersed in water, bring it to a service center. Before using Check the voltage rating of the vacuum cleaner before connecting the power cord to an electrical outlet. [. . . ] When using the vacuum with an Electrobrush and current-carrying hose: The hose contains electrical wires. Do not use if damaged, cut, or punctured. The socket on the vacuum cleaner (depending on model) must only be used for the Miele Electrobrush specified for use with this appliance. Only use attachments specified by Miele. Do not use the blower to operate paint sprayers or similar devices that emit volatile or toxic vapors. Monitor the dustbag change indicator and inspect all filters regularly. To ensure efficient suction, clean or replace them when necessary according to the operating instructions. To guarantee safety, only use genuine Miele dustbags, filters and accessories. Miele vacuum cleaner bags are disposable and are only to be used once. Do not use the vacuum without an accessory attached. The rim could be damaged and injuries could result from sharp edges. Maintenance and care A damaged power cord must only be replaced with a genuine Miele cord by an authorized service agent. When the wand bracket is folded out the telescopic wand with suction hose and floor brush can be attached to the handle of the vacuum. 11 Before using the vacuum Attaching the floor brush ^ Insert the telescopic wand into the floor brush and turn in either direction until it locks with a click. ^ To release the floor brush from the telescopic wand, press the locking button (see arrow) and pull the wand out of the floor brush. The floor brush is suitable for cleaning carpets, rugs, and hard surfaces. For flooring susceptible to scratches, use one of the special Miele floor brushes (see "Optional accessories"). Observe the cleaning instructions of the floor manufacturer. Adjusting the floor brush Vacuum carpets and rugs with the brush retracted: ^ Press the foot switch marked g. Clean hard flooring with the brush protruding: ^ Press the foot switch marked h. 12 Included accessories The accessory tools for cleaning tough to reach areas are located in the accessory compartment. ­ Crevice nozzle ­ Upholstery tool ^ Press the release button to open the accessories compartment lid. ^ Remove the accessory tool. ^ Close the lid. 13 Included accessories The different tools can either be fitted to the handpiece or to the telescopic wand. Crevice nozzle For cleaning in folds, crevices or corners. Upholstery tool For cleaning upholstery, mattresses, cushions, curtains, covers, etc. 14 Use Power cord Unwinding ^ Hold the plug and unwind as much of the cord as you need (maximum length 21' 4" [6. 5 m]). , If the vacuum is operated for more than 30 minutes, atleast 14 feet (4. 3 m) of the power cord must be unwound to prevent overheating. Rewinding ^ Unplug the vacuum from the outlet. ^ Step on the rewind switch to automatically rewind the power cord. Lightly hold the plug so that it does not whip around when rewinding. 15 Use Turning the vacuum on and off To turn the vacuum cleaner on or off: ^ Step on the On-Off foot switch. , To prevent static discharge, your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when vacuuming fine dust, flour, or saw dust as these materials are most likely to create static discharge. [. . . ] ^ Close the filter frame. Dust compartment filter ^ Open the dust compartment lid. ^ Close the dust compartment lid. 24 Vacuum care Changing the thread catcher The thread catcher pads on the bottom of the rug and floor tool should be checked occasionally. ^ Use a screwdriver as shown to remove the thread catcher from the slot. ^ Press the new thread catcher into the slot. [. . . ]