User manual MIELE W 1926 WASHING MACHINE OPERATING MANUAL

[. . . ] Operating Instructions for the W 1926 Washing Machine To prevent accidents and machine damage, read these Operating Instructions before installation or use. ö M. -Nr. 04 955 390 Contents Contents Guide to the machine. 5 Preparation for use Help protect our environment . 6 Operating Instructions Optimal usage . [. . . ] 2 quarts (2 l) of water will drain out of the hose. If the main drain hose is clogged, more water will be retained in the machine (max. In this case, tighten the lint trap lid and empty the dish before repeating the procedure as often as necessary. Caution: If laundry has been washed at a high temperature, the water draining out of the machine will still be hot!Stop and allow it to cool before proceeding. To clean the lint trap, remove the tool from behind the detergent dispenser drawer. ^ Open the lint trap door. 22 Cleaning and care ^ Once the flow of water stops, remove the lint trap and clean it. ^ Clean the inside of the lint trap housing. ^ Turn the drain pump impeller (in the back of the chamber) by hand to check that it rotates freely. Remove any detergent deposits or foreign objects from the thread of the filter housing and filter unit before replacing the lint trap. 23 Cleaning and care Cleaning the water inlet filters. The washing machine has two water inlet filters to protect each inlet valve. To clean the filter in the inlet hose: ^ Turn off the valve. ^ Carefully unscrew the inlet hose from the valve by turning the connector counterclockwise using a wrench if necessary. ^ Remove the rubber seal from the connector. The hose should be replaced if there are small cracks in the surface, or if it has been otherwise damaged or cut. If a replacement is necessary, use only a genuine Miele inlet hose as other hoses may burst under pressure. To clean the filter in the inlet valve: ^ Using a wrench, carefully loosen and remove the plastic hose connector on the inlet valve. ^ Using needle nose pliers, grasp the plastic filter and pull it out of the hose connector. Clean the filter under running water and carefully remove any large particles. ^ Replace the filter and seal and reconnect the hose. Slowly turn on the valve and check for leaks. ^ Using needle nose pliers, withdraw the plastic filter by pulling on the bar (see illustration). Rinse under water to clean, and then replace. The two filters - one at the pressure hose/valve connection and one at the inlet connection to the solenoid valve - must not be removed. 24 Problem solving guide Problem solving guide Any work done on the electrical components of this appliance should only be performed by a qualified technician in accordance with all local and national codes and regulations. Unauthorized repairs may result in personal injury and machine damage. What to do if, . The "ON" indicator lamp has not lit up. Remedy . The "Check indicator lamps are flashing? Check that. . : ­ the door is properly closed. ­ the fuse or circuit breaker has not tripped. [. . . ] If the Program Selector is turned to its original position, the "On" lamp will stop flashing. To change a program once the Program Lock is activated: ^ Turn the Program Selector to "Finish/Start". After about 30 seconds, the sequence indicator lamps will start flashing in succession. A new program can be selected as soon as the "On" lamp is the only one remaining lit. A High water level (only in "Cottons" rinses) Where rinse results are particularly important (e. g. [. . . ]