User manual MINOLTA MAGICOLOR 2300 DL

[. . . ] magicolor 2300 DL User's Guide ® 1800687-001 EDNord Istedgade 37A, 9000 Aalborg - Telefon 9633 3500 Thank You Thank you for purchasing a MINOLTA-QMS printer. Trademarks The following are registered trademarks of MINOLTA-QMS, Inc. : QMS, the MINOLTA-QMS logo, and magicolor. Minolta is a trademark of Minolta Co. , Ltd. Other product names mentioned in this guide may also be trademarks or registered trademarks of their respective owners. This product uses Software Developer Kit of Peerless Systems Corporation. [. . . ] The printer is set to power saving mode. The job is very complex. Solution It takes more time to print with special media. When using regular paper, make sure that the media type is set properly in the driver. It takes time for printing to start in power saving mode. If you do not want to use this mode, disable it. No action needed. The printer memory is Add more memory. Blank pages come out during a printing job. One or more of the toner cartridges are defective or empty. The image does not print if the cartridges are empty. Check that the media type set in the driver matches the media loaded in the printer. Printer returned to IDLE before the menu was changed. The printer was in the When in the menu structure, select menu structure your choice before two minutes elapse. without a selection being made within two minutes. Check your cable. Not all pages The printer has the print. wrong kind of cable, or the printer is not configured for the correct cable and port. A document is printed with an overlay file which has been created by a non-magicolor 2300 DL driver. Make sure no one pressed the Cancel key while your job was printing. Check that the media trays are loaded with media, in place, and secure. Print the overlay file using a magicolor 2300 DL driver from the magicolor 2300 DL Utilities and Documentation CD-ROM. 90 EDNord Istedgade 37A, 9000 Aalborg - Telefon 9633 3500 Solving Other Problems Symptom Printer resets or turns off frequently. Cause Solution The power cord is not Turn off the unit, confirm that the power properly connected to cord is properly connected to the AC the AC outlet. Contact Technical Support with the error information. See the Service & Support Guide for a list of sources of service and support in the Americas. The most up-to-date worldwide information can be found at www. minolta-qms. com. For autoduplexing, make sure that you have a duplex option installed. Make sure that you are using correct media. See the table on page 11 for supported media. [. . . ] The result could be an electric shock or a fire. Remove from the power cord from the socket with wet hands as this may result in an electric shock. Place any heavy objects on the power cord. Do not pull or kink the cord as this can result in damage to the cord. [. . . ]