User manual MINOURA B60-D

[. . . ] Be sure that it is not possible to convert a hub nut type wheel axle to a quick rekease skewer type unless replacing the wheel hub itself. · Use on flat and level floor or ground for your safety. · Adjust the roller pressure to the rear tire properly in order to maximize your tire life. Tire-to-roller contact will eventually wear both your tire and the trainer roller. [. . . ] It's not possible to convert your wheel from the hub nut type to the quick release skewer type unless replacing the hub. ! 2. Install the Roller Pressure Adjust Knob set (MF-3) to the welded nut on the B60 frame. A) ! Make sure the acorn shaped spring direction is as shown in Fig. Failure will cause difficulty on rotating. (Fig. A) 3. Fully open both legs and place B60 on a flat and level floor. At this moment, make sure all 4 foot are contacting the floor at once to sit on the floor stable. B) - Page 4 - (Fig. B) 4. Place your rear wheel in between the couplings. 1) Turn the Hub Handle in the direction of counter-clockwise to make the enough space between the couplings. You should almost fully open the coupling for easier wheel installation. C) ! Be careful not to over-loosen the Hub Handle. It will loosen the inside nut and no longer proper tightening can be expected. (Fig. C) 2) Insert the left side (quick lever side) skewer into the left side coupling first. The quick lever shaft must be inserted into the cut-out on the coupling to hold the bike stable. Turn the coupling to adjust the cut-out position prior to tightening the Hub Handle. 3) While keeping this position, slowly come down the bike to align the right side acorn nut to the right side coupling. 4) Turn the Hub Handle clockwise to hold the rear wheel. Once the rear wheel hub is stiffly caught between the couplings and you see the frame starts opening, it's the bottom position. 6) Turn the Hub Handle two more rotations. Do not try to over-tighten the Hub Handle. ! Both right and left side couplings are designed to suit the supplied quick release skewer. The left side coupling must fit perfectly in the skewer head to get correct stability. D) Any skewer type which lever is located on the end of the axle (see Fig. E) or the lever will not be bent over right angle (see Fig. F) cannot be used on B60. (Fig. D) ! Do not try to over-tighten the Hub Handle to keep the correct thightness of rear hub clamping. Too tight setting will cause damage to both B60 and your bike frame. [. . . ] M-1) following section. 2. Flip up the lever to lock (see Fig. M-2). If it is loosened, adjust the band tighter as per instructed in the 3. The soft fabric band is pre-adjusted to fit normal 22mm diameter handlebar. If you need to mount onto an oversized or specially shaped handlebar or stem, adjust the band (see Fig. At this moment, we suggest you to slide the guide pin downward (see the column) to loosen the band for easier work. Decrease 1 2 1 (Fig. N) (Fig. O) (Fig. M) 3 2 Increase 4. To increase the resistance, twist the lever toward "H". To decrease the resistance, twist the lever towawrd "L". [. . . ]