User manual MINOURA BIKE PIT

[. . . ] Bike Tower MUST be installed firmly on a a solid floor and ceiling using a supporting beam or load bearing area of the ceiling. Failure to do so may cause damage to your ceiling, bikes, Bike Tower, and may cause personal injury. ! Set the Bike Tower up vertically from floor to ceiling. Make sure the Bike Tower is not slanted. Slanted installation may cause the Bike Tower to fall down, causing damage and/or injury. X ! Set Bike Tower firmly against a supporting beam or load bearing area of the ceiling. [. . . ] Slanted installation may cause the Bike Tower to fall down, causing damage and/or injury. X ! Set Bike Tower firmly against a supporting beam or load bearing area of the ceiling. Failure to do so will cause damage to your ceiling. ceiling supporting beam ! When setting the main telescoping pole, make sure to extend it until the red warning sign no longer shows. The warning sign is located just below the upper rubber cup. -1Red Warning Sign HOW TO SETUP BIKE PIT We explain the name of each part as below; Required tool : 5mm hex wrench (included) Upper Rubber Cup Lower Support Angle Adjust Plate (projection is foreside) Height range: 1. 6m (5'3") - 3. 1m (10'2") Upper Pole Pole Joint Alloy Stay Frame Hook Lower Pole Bottom Rubber Cup 1 Loosen the upper bolt on the Pole Joint then extend the main pole. After you fit the main pole to the ceiling, tighten the bolt slightly. A) Tighten temporaly 2 Remove the main pole, making sure the pole length is not changed. Extend the main pole 20mm more, then tighten the upper bolt on the Pole Joint firmly to set the pole length. A) +20mm ! A loose the bolt on the pole joint may cause the pole to slide down when a bicycle is in the cradle. Overtightening the bolt on the pole joint may cause the plastic pole joint to break. Make sure the pole joint bolt is snug and that the joint will not move. loosen and tighten (Fig. G) ! If the red warning sign is visible below the rubber cup even after following the above instructions, the pole extension is too short and may cause the bikes to fall over. Please start the installation process over again to insure proper set up and that the red warning label does not appear. 2 (Fig. G) ! Make sure the Bike Tower is set up vertically with no slant. Failure to do so may cause equipment or personal damage. If you want to move the cradle, loosend the lower bolt on the angle adjust plate, change the angle until the displayed bike will be horizontally as much as possible then tighten the bolt again. H) HOW TO USE BIKE PIT Bike Tower can stand alone, but we recommend it is set-up next to a wall for increased safety. Lift the bicycle and gently place the top tube into the frame hooks. If the bicycle does not have a standard frame design, it should be supported by the top tube and rear seatstay configuration. I) BIKE PIT USE CHECK LIST You must check the following points before use; 1. Check that there are no cracks in the main pole or plastic brackets. [. . . ] I) BIKE PIT USE CHECK LIST You must check the following points before use; 1. Check that there are no cracks in the main pole or plastic brackets. Check that all fittings are securely fastened. Check to make sure the main pole is not bent or developing any rust. WHY MY NUT IS MISALIGNED? The inside nut of the stainless band clamp is not square, it is rectanle. [. . . ]