User manual MINOURA E-RDA-850-LW

[. . . ] Check the couplings supporting the rear hub for damage and cracks. Accidents may occur from cracked or damaged couplings. A) You should not tighten the wheel axle by tightening the left side knob. This is for pre-adjusting the wheel position to the exactly center of the drive roller only. [. . . ] G) Each rubber roller is made to contact the rim ONLY. Contact with the tire may cause the tire to burst during use. (Fig. G) ! 7 Adjust the wheel position by checking the double-circle position indicators on both side. The best position should be each indicator can be seen equally, but if your rim is narrow, you should adjust the wheel position to be a little left (toward Mag side) to prevent unexpected slippage problem. NOTE: Note that the left side knob is NOT for tightening the axle. Clamping wheel securely must be done by the right side hub handle. (Fig. H) USING THE PLATIC SKEWER NUT PROTECTOR We recommend that you use the supplied skewer if at all possible. This will gaurantee a fit with our couplings and remove any chance of misalignment. Hole (Fig. I) The right side coupling has a black plastic skewer nut protector (called a "Grommet"). This is to protect your skewer from damage during use, however, should you choose to use your own skewer, you should use the supplied grommet to insure a better fit. We will NOT guarantee any fitting problem or accident caused by using your own skewer on the trainer. When you use the supplied skewer, you should remove the grommet from the coupling. It can be done by inserting a rod or a pen to the hole (see Fig. I) and then lifting up the grommet. -5- HOW TO INSTALL THE REMOTE LEVER You can install the remote lever on anywhere the diameter is between 22. 2mm (7/8") and 31. 8mm (1-1/4") like as on the handlebar. 1 2 Fully loosen the knob bolt on the plastic holder until it stops then push down the bolt to open the holder. J) Place the holder onto the handlebar, shut the holder, and pull up the bolt then tighten it. K-2) Depends on the diameter of your handlebar, you must adjust the shim as follows; · 22. 2mm (7/8") - 25. 4mm (1"): Install both shims. · 28. 6mm (1-1/8"): Install either right or left side shim. · 31. 8mm (1-1/4"): Remove both shims. USING THE MAG RESISTANCE UNIT ! When you install the shim on the plastic holder, make sure the direction of the shim as shown in Fig. J-2. The Mag unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter type remote lever device. You may also adjust the load force by shifting up or down among your gears, depending on the level desired. We recommend that you start with a medium to low load force and gradually work up, increasing force as your muscles warm up. Increasing Load Force To increase the load force, move the white lever on the Mag unit toward the (H) symbol. L) If your Mag unit is a remote control type, turn the lever on your thumb shifter device toward the (H) symbol. [. . . ] You should keep a memo where the bottom pin of the spring was installed for returning to dial type again. Change the spring position as shown in the Fig. P) 3 4 5 Place the spring holder onto the spring. Be sure the top pin is inserted into the slot of the holder. [. . . ]