User manual MINOURA HYPERMAG

[. . . ] The clamp handles should be a snug and secure fit. ! Keep away from small children, hands and feet away from spinning rollers and wheels at all times. Before use, make sure all bolts and nuts are securely fastened. !! "ICE" system cannot be used on the HyperMag resistance unit. If you will use HyperMag with an MTB, you should change your rear tire to a slick one from a knobby one in order to prevent any problems caused by noise and vibration. Also be sure there may be a problem that your tire will worn out easily if the roller pressure to the tire is too weak or too strong. [. . . ] The resistance unit is located behind the bike. 1 Loosen the knob bolt and lay down the resistance unit in order to make the space for the rear wheel enough. Loosen the hub clamping handle to make the clearance between the couplings wider. Place your bike in front of the HyperMag and pull back the bike between the frame pillars. Lift up the rear part of the bike and attach the left side hub (Q/R side) into the left coupling (see Fig. If the lever part of the skewer touches the edge of the coupling, it may be damaged and your weight will not be able to be supported safely. To avoid this problem, adjust the angle of the ring on the coupling to be that the lever will come to the horrow of the ring. (Fig. D) 3 ! Lift up the bike with using the left hub as the fulcrum and make the rear axle horizontal. Tighten the hub clamping handle and catch the right side (rear cog side) hub with the coupling. Harder clamping can supports the bike firmly, but over-tighten may cause a damage on your bike or HyperMag. Stop tightening when the frame pillars start to move outward. Also you must confirm the stability of the bike everytime you use the HyperMag with shaking the bike slightly. 4 5 If you are the Type-R user, install the remote control device onto the handlebar. Lastly, tighten the knob bolt to press the drive roller to the tire. Be sure that you should stop thightening when the roller touches the tire, then tighten a half or 1 rotation more (see Fig. If the roller pressure to the tire is too weak or too strong, your tire may worn down incredibly easily. To avoid such problem, keep the pressure properly. ! (Fig. G) ADJUSTING THE LOAD LEVEL You can choose from 7 different load levels with shifting the adjusting dial (Type-D) or the remote shifter lever (Type-R). <INCREASING LOAD LEVEL> If your model is Type-D, turn the load adjusting dial to the direction of "H" symbol (see Fig. If your model is Type-R, twist the remote shifter lever to the direction of "H" symbol (see Fig. Be sure there will be remained minimum load resistance even you shift the lowest position (L). This is caused by the pressure of the drive roller to the tire. Increasing (Fig. [. . . ] I) ABOUT OPTIONAL ITEMS ·REMOTE SHIFTER KIT If you are the Type-D (dial version) owner, you can change the outer case of the resistance unit to be TypeR (remote version). Order "Remote Shifter Kit" at your local Minoura dealer. ·HYPER-BRAIN CYCLE COMPUTER "HyperBrain" cycle computer is available as a convenient option for both Type-D and Type-R. This computer features 7 functions and measures the speed data directly from the drive roller, not from the wheel like as normal cycle computer. So you can expect always exact speed data even you use different size wheel on the HyperMag. [. . . ]