User manual MINOURA W-3100

[. . . ] Repairstand "W-3100" instructions manual Gear Clutch PARTS NAME Clutch Release Lever Clamp Jaws Back Knob Clamp Adjust Knob Clamp Lever Upper Pillar Tool Tray (option) Lock Bolt Upper Pillar Holding Bolt Lower Frame Left Side Leg Adjusting Screw Right Side Leg HOW TO ASSEMBLE W-3100 Required Tools: 1 x 13mm Spanner 1 x 6mm Hex Wrench 1 x 5mm Hex Wrench 1 Assemble both Legs to the Lower Frame with the supplied M8x40 bolts and M8 Nylon Nuts. M8 Nylon nut M8x40 Cap Bolt 2 Place the assembled Lower Frame on the floor, and check if every Adjusting Screw is touching the floor perfectly. [. . . ] Fix the position, then tighten the knob bolt. Lock Bolt HOW TO CLAMP YOUR BIKE (Maximum Load Capacity: 40 kgs / 90 lbs) 1 Pull down the Clamp Lever to open the jaws. 2 Place the top frame or the seat pillar onto the lower jaw, then fully pull up the Clamp Lever to close the jaws. 3 Turn the Clamp Adjust Knob clockwise to securely hold the bike. Turning counter-clockwise will widen the opening. 4 To rotate the clamp jaws, push down the Clutch Release Lever then rotate the jaws. Release your finger after confirming the ratch is securely engaged to the gear. ABOUT OUR WARRANTY PROGRAM You are covered under our warranty program for maximum 5 years from the date of your purchase. Any defects caused by the manufacturer's mistake will be solved with this program at manufacturer's expense, but any problem caused by the user's misuse or natural worn will not be supported by this program. [. . . ] Phone: 1-510-538-8599 Fax: 1-510-538-5899 Email: support@minourausa. com MINOURA JAPAN HEADQUARTERS (for all other customers) 1197-1 Godo, Anpachi, Gifu 503-2305 Japan Fax: 81-584-27-7505 Email: minoura@minoura. jp Web: www. minoura. jp MADE IN JAPAN W-3100 / SMALL PARTS LIST C-4 C-11 C-3 C-6 C-7 P-4 P-3 C-9 C-10 C-4 C-8 P-1 C-11 T-4 T-2 C-3: C-4: C-6: C-7: C-8: C-9: C-10: C-11: P-1: P-3: P-4: P-5: P-7: P-8: P-9: L-3: L-4: L-9: L-10: L-11: T-2: T-4: Clamp Rubber Lock Clip Clamp Shaft Clutch Packing Clamp Space Collar M8 Flat Washer Back Knob Clamp Jaws Assy Upper Pillar Clutch Release Lever Pivot Screw Pillar Cap Upper Pillar Holding Bolt & Nut Lock Bolt Lower Frame Leg End Cap Adjusting Screw Left Side Leg Right Side Leg M8x40 Bolt & M8 Nylon Nut Tray Fixing Knob Bolt Tool Tray w/ tool slots L-3 L-4 L-10 L-3 L-4 L-9 L-11 L-11 P-7 P-9 P-7 P-5 P-8 [. . . ]