User manual MIO C210-HARDWARE

[. . . ] 14 Right-Side Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 Top Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Bottom Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 2 Basic Skills . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 2. 1 2. 2 2. 3 Turning Your Device On and Off . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Slide the back cover into place and make sure it clicks into position. 7 CAUTION: Immediately replace the batteries whenever the batteries are low. It is important that the batteries have power for the device operation even though power can be supplied to your device through the in-car power cable or USB cable. Failure to do so can result in damage to your device. When replacing the batteries, use the batteries of the same type and manufacturer. Do not mix the use of old and new batteries. When not using the battery for a long period (more than one month), remove the batteries to prevent damage from battery corrosion. In case the battery leaks, clean the liquid and install new batteries. NOTE: After replacing the batteries, you need to press the power button for five seconds to turn on your device. (See the following section for more information. ) Depending on the characteristics of different battery types, the length of operation time might differ from one to the other. Check the regulations of your local government for proper battery disposal. 1. 2 Performing the Initial Start Up 1. Make sure that power is supplied to your device either by batteries or by the in-car power cable. For the initial start up, press the power button for five seconds to turn on your device. NOTE: For normal operation, briefly press the power button to turn on and off your dvice. 3. You can tap the left/right arrow to select a language. Then tap to save the changes. 8 4. Tap the arrow button to select the time zone, date and time for your system. You can now start using your device. 9 1. 3 Using Your Device in a Vehicle A car holder and an in-car power cable are supplied with your device. Using the Car Holder CAUTION: Select an appropriate location for the car holder. Never place the holder where the driver's field of vision is blocked. If the car's windshield has window tint, it is recommended that you use a car antenna (optional) to route the antenna to the top of the car through the window. When closing the car window, be careful not to pinch the antenna. (For a car with the anti-jam design, the window will automatically leave space. ) Use the car holder to fix the device near the windshield. Connecting the In-Car Power Cable The in-car power cable supplies power to your device when you are using the device in a car. CAUTION: To protect your device against sudden surges in current, connect the in-car power cable only after the car engine has been started. If you are using the rechargeable batteries, connecting to the in-car power cannot provide power to your batteries. 1. Connect the one end of the in-car power cable to the cigarette lighter in the car. [. . . ] Compliance with these directives implies conformity to the following European Standards: EN301489-1: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements EN301489-3: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 3: Specific conditions for Short-Range Devices (SRD) operating on frequencies between 9 kHz and 40 GHz EN55022: Radio disturbance characteristics 28 EN55024: Immunity characteristics EN6100-3-2: Limits for harmonic current emissions EN6100-3-3: Limitation of voltage fluctuation and flicker in low-voltage supply system EN60950 / IEC 60950: Product Safety The manufacturer cannot be held responsible for modifications made by the User and the consequences thereof, which may alter the conformity of the product with the CE Marking. 4. 2 Safety Precautions Use only the in-car power cable (ATECH, ATPI-68HT0501-NC1. 0) supplied with your device. Use of another type of in-car power cable will result in malfunction and/or danger. This product is intended to be supplied by a LISTED Power Unit marked with "LPS", "Limited Power Source" and output rated + 5 V dc / 1. 0 A". Do not mutilate, puncture, or dispose of battery in fire. [. . . ]