User manual MITSUBISHI 3DC-1000

[. . . ] · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi- WARNING. [. . . ] A continuously blinking red LED indicates low battery power. See lithium-battery safety information at the front of this booklet. Open the cover. Remove the old battery if present. Insert a new Close the cover. battery, positive (+) side facing out. For assistance call 1(800) 332-2119 8 Using the 3D Glasses 3D Glasses Operation 1. Turn on 3D Mode in the TV and 3D source device. Press the POWER button on the glasses to turn on the glasses. When the 3D program is complete, turn off 3D mode in the TV and 3D source device and turn off the glasses. On Operating Range Be from 5 to 20 feet away. Press POWER button. The red LED will light for three seconds. 20 ft. 5 ft. 50° 50° Off Hold POWER button for about two seconds. Red LED will blink three times. Notes On the 3D Glasses · · · Shut off 3D glasses when not in use to extend battery life. Fluorescent and halogen lighting can cause the 3D glasses to flicker. Turn off these lamps if flickering occurs. Turning off the TV's 3D mode or changing the TV's input to a 2D input will turn off the IR emitter; the glasses will turn off automatically after two minutes. Moving out of range of the IR emitter for more than two minutes will cause the glasses to turn off automatically. Interference from other IR sources, such as motion detection devices, may cause the glasses to flicker or work intermittently. Turn off other IR source if interference occurs. The IR emitter in this system can also be used with Samsung 3D glasses model SSG-2100AB. Information about these glasses can be obtained from Samsung USA at www. samsung. com/usa/. You can also check www. mitsubishi-tv. com for any updates about compatible glasses. · · · · Please check www. mitsubishi-tv. com for updates on 3D signals and safety. 9 Cleaning Instructions · To avoid scratching the glasses, use only standard glasses lens cleaning cloth, microfiber cloth, or a soft non-scratching cloth such as cotton flannel. Make sure the cloth is clean and free of any foreign material that may scratch the glasses. Cloths pre-moistened with cleaning solutions designed specifically for eye glasses can be used, however, do not spray solutions directly on the glasses. DO NOT spray any cleaner directly onto the any surface of the glasses. This may result in fire, electric shock, damage to the product surface, or removal of control labels. [. . . ] Consumable parts such as batteries, 3D Glasses and IR Emitters that were not sold as a part of the Starter Kit (refer to the instructions for the glasses and IR Emitter for warranty details), cosmetic damage or any other damage where such damage is caused by unauthorized modification, alteration, repairs to or service of the product by anyone other than an authorized MITSUBISHI For assistance call 1(800) 332-2119 12 service center; physical abuse to or misuse of the product (including any failure to carry out any maintenance as described in the Owner's Guide or any product damaged by excessive physical or electrical stress); any products that have had a serial number or any part thereof altered, defaced or removed; product use in any manner contrary to the Owner's Guide; freight damage; or any damage caused by acts of God or other factors beyond the reasonable control of MDEA, such as power surge damage caused by electrical system or lightning. This limited warranty also excludes service where no defect in the product covered under this warranty is found, service related to unsatisfactory audio or visual reception or signal unless caused by a defect in the product that is covered under this limited warranty, all costs, expenses or any other damages arising from product installation, or set-ups, any adjustments of user controls (including contrast, brightness, color, tint, fine tuning, sharpness to the connected TV), other adjustment necessary to prepare the unit for display or use, connection with any external audio receiver, antenna, cable or satellite systems, or service of products purchased or serviced outside the U. S. A. Please consult the operating instructions contained in the Owner's Guide furnished with the product for information regarding user controls. ANY EXPRESS WARRANTY NOT PROVIDED HEREIN, AND ANY REMEDY WHICH, BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION OR OPERATION OF LAW, IS HEREBY EXCLUDED AND DISCLAIMED. [. . . ]