User manual MITSUBISHI AH129

[. . . ] Before Use A new battery must be fully charged before initial use. INSTALLING THE BATTERY Insert the top of the battery into the recess on the back of the phone. Attach it to the phone by pressing slightly upward on the battery and in at the bottom until the locking catch snaps into place. Make sure the battery is properly secured. Getting Started REMOVING THE BATTERY Turn the power off before removing the battery. To remove the battery, press the bottom upward and gently lift the battery off the phone. 1 CHARGING THE BATTERY FOR THE FIRST TIME Connect the AC rapid charging plug into the socket at the base of the phone and plug it into a standard 120 volt AC outlet. [. . . ] If the key is invalid, the display shows "Invalid" for approximately two (2) seconds and returns to the A-KEY re-entry state. Note: During the A-KEY programming mode the "END" key can be used to cancel and exit from this mode at any time. If the new A-KEY is entered, the existing A-KEY is overwritten by the new A-KEY. Once the A-KEY is programmed, it may not be viewed through the display or any device attached to the phone. FUNCTION MENU User action: FCN + FCN Menu w To RCL RCL -MenuPush v/w w/v (FCN FCN) (Standby only) Action FCN 1 Own Tel w/v FCN Tel:123 4567890 26 FCN 2 Alpha w/v FCN Alpha Input FCN 3 Redial w/v FCN Redial ON FCN 4 System w/v FCN System Pref A FCN 5 AutoAns w/v FCN AutoAns OFF FCN 6 Lock v w FCN Lock Code FCN 7 Last w/v FCN Last MMmSSs FCN 8 Oper w/v FCN Oper HHHhMMm FCN 91 Restr. w/v FCN Security Code Security Code Restr. NoRestr Unlock 123 FCN 92 Unlock w/v FCN 27 FCN 93 Status w/v FCN Security Code Security Code Status ON PIN ON FCN 94 PIN w/v FCN FCN 95 PIN No. v FCN Secure Code PIN No. 1234 DIRECT ACCESS FUNCTION w FCN 0 Pause w/v FCN(1s) Mute w/v FCN(1s) View w/v FCN STO AutoSto w/v FCNSEND AutDTMF w/v FCN v/w RingVol w/v 28 Conversation Conversation RCL v/w MemScan w/v RCL RCL Last No w / v Back to FCN 1 Note: The function menu is not available in conversation mode. In standby mode, the "STO" or "END" key can be used to exit from the function mode. FCN 1 : Telephone Number Function (Standby & Conversation) Press "FCN" and "1". Tel:123 4567890 Function: When the user enters the "FCN" key followed by "1", the phone enters "Own Telephone Number Display mode". Your own telephone number is then displayed. In standby mode, this function is also used to switch NAMs. This may be done by pressing the "*" or "#" key. When first pressing either key, it will display the current NAM number and telephone number. Subsequent key presses will toggle the NAM selection. 1: 123 4567890 Press */# key 2: 321 7890456 In order to exit from this mode, press the "STO, " "END, " or "CLR" key. 29 If the phone is locked, this operation is ignored. Note: This function operates even if the phone is in conversation mode. NAM switching can only be done in standby mode. To exit from conversation mode, press "STO" or "CLR". FCN 2: Input/Edit Alphabet Name And Number Direct Operation: (number) +FCN + 2 +(alphabet)+ STO "FCN" + "STO" or "STO" + "XX" (0139 only) in Standby mode only Display: When FCN + 2 is pressed: Alpha Input is displayed. Function: A maximum of 11 alphanumeric characters can be stored into the name area and up to 32 digits can be stored into the number area. In the alphabet mode, digit keys are used for alphanumeric entry. The characters table is: KEY CHARACTERS 1QZ_ 1 2ABC 2 3DEF 3 4GHI 4 5J KL 5 6MNO6 7P RS 7 8T UV 8 9WXY 9 0O *. #- , ! " ? * # 30 Example: Press "2" key once Press "2" key twice Press "2" key three times Press "2" key four times Press "2" key five times = "A" = "B" = "C" = "2" = "A" To complete your selection, press the key for one (1) second or press another key. If a key must be repeated, the user must press the key for one (1) second in order to advance to the next character. Example (a): Input new name and number Name "DAVE" / Number "2133932111" Operation Enter number FCN + 2 One second later 3 once 2 once 8 three times 3 twice FCN+STO or STO+XX (01 to 39) Display 213 3932111 Alpha Input ??: ALPHA D ALPHA DA ALPHA DAV ALPHA DAVE ALPHA Stored Addr. XX 31 Note: · If a character is repeated, the key must be held for one (1) second in order to advance to the next character. · "ALPHA" indicates that the phone is in the Input/ Edit mode. [. . . ] Use only the supplied or approved antenna. Non-approved antennas, modifications, or attachments could impair call quality, damage the phone, and violate FCC regulations. 52 Driving Check the laws and regulations on the use of cellular telephones in the areas where you drive. Also, when using your phone while driving, please: · · give full attention to driving, use hands-free operation, if available, and · pull off the road and park before making or answering a call if driving conditions so require. Electronic Devices Most modern electronic equipment is shielded from RF energy. However, RF energy from cellular telephones may affect inadequately shielded electronic equipment. [. . . ]