User manual MITSUBISHI AH250

[. . . ] Getting Started Even if you don't like reading manuals, please read this section as well as Commonly Used Features (beginning on page 7) to understand how to use some of the phone's basic features and functions. In this section you will learn about: · · · · · · · The Telephone Display Using the Keypad Using Functions Turning the Phone On and Off Dialing Notes and Error Tones Placing and Receiving Calls Battery Information Getting Started The Telephone Display The Battery Level Indicator displays 3 levels of power. When its outline flashes, the battery is low. In fast charging, the entire indicator flashes. [. . . ] Press FCN 82, then enter the Security Code. To create a new Unlock Code, enter 3 digits for the new code. If you make a mistake, or if you do not want to use the new Unlock Code, press CLR to use the original code. If you did not make any changes, press CLR to exit this mode. Press END to save the new code and exit this mode. NOTE: You can program a new Unlock Code even while the phone is locked. 16 Status Monitor 1. Press FCN 83, and enter the Security Code. Press i / # to enable or disable the Status Monitor. Press END to save your setting and return to Standby. Status Monitor Messages Status Monitor Messages display in the following formats: Conversation Mode Non-Conversation Mode CCCCRRR A XXXXX Message. . . CCCC RRR A CCCCRRR PSXXXXX Features XXXXX P S Description. . . Voice channel or control channel in Standby Received RSSI Serving system support level for authentication 0=Not Supported, 1=Supported Received SID Transmit power level 0-7 Received SAT frequency 0=5970 Hz, 1=6000 Hz, 2=6030 Hz, 3=no SAT 17 PIN Number Programming If your service provider supports this feature, a PIN must be sent whenever you make a call. Rather than entering it each time, you can program the phone to send the PIN automatically. Press FCN 84, followed by your Security Code. If there is no current PIN, a line of dashes displays. To change the PIN, enter the desired 4-digit PIN. If you make a mistake, or if you do not want to use the new PIN, press CLR to use the original PIN. If you did not make any changes, press CLR to exit this mode. Press END to save the new PIN and return to Standby mode. Features Enabling Automatic PIN With Automatic PIN enabled, the phone sends the PIN automatically when required by the cellular system. Press FCN 85 followed by the Security Code. The status of the PIN (ON or OFF) displays. If there is no PIN programmed, No Pin displays. Press i / # to enable or disable Automatic PIN. [. . . ] Posted Facilities Turn your phone OFF in any facility where posted notices so require. Aircraft FCC regulations prohibit using your phone while in the air. Switch your phone OFF before boarding an aircraft. Blasting Areas To avoid interfering with blasting operations, turn your phone OFF when in a blasting area, or in areas posted Turn off two-way radio. Obey all signals and instructions. 30 Potentially Explosive Atmospheres Turn your phone OFF when in any area with a potentially explosive atmosphere and obey all signs and instructions. Sparks in such areas could cause an explosion or fire resulting in bodily injury or even death. [. . . ]