User manual MITSUBISHI CP-9000DW

[. . . ] DIGITAL COLOR PRINTER MODEL CP9000DW OPERATION MANUAL POWER ALARM PAPER/INK RIBBON DATA READY COOLING DOOR OPEN CANCEL FEED&CUT THIS OPERATION MANUAL IS IMPORTANT TO YOU. PLEASE READ IT BEFORE USING YOUR DIGITAL COLOR PRINTER. This digital color printer complies with the requirements and other relevant provisions of the EC Directive 89/336/EEC, 73/23/EEC, 93/68/EEC and 1999/ 5/EC. The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. All places of operation are characterised by their connection to the public low voltage power supply system. INFORMATION This Class A digital apparatus complies with Canadian ICES-003. [. . . ] 7 Turn on the power of the personal computer. CONTENTS 10 CONNECTIONS SETTING OF DIP SWITCHES 2 SETTING DIP SWITCHES All the switches are set to OFF at the time of shipment from the factory. Turn off the power before changing the DIP switch settings. PRECAUTIONS OFF ON Switch No. Setting Function 1 OFF Auto feed & cut mode When the door is closed after the print paper or a ink cassette is installed with this unit powered on, this unit automatically carries out paper feed & cut operation. ON Manual feed & cut mode 2 OFF Set this switch to OFF. ON 12345678 FEATURES CONNECTIONS PREPARATION TROUBLESHOOTING OTHERS CONTENTS 11 BEFORE OPERATION Before printing, PRECAUTIONS 1 Install the print paper to this unit. (See below. ) 2 Install the ink ribbon to this unit. (page 14-15) INSTALLATION OF PRINT PAPER latches FEATURES Spacers 2 The spacers are attached to the paper flanges. For the necessity of the spacers, see the Quick Setup Guide. Remove the cushions put between the paper flange and spacer when use them. Turn the spacer until the latches are unlocked. Remove the spacer with the paper flange's stoppers retracted. When you use the print paper with which the spacers have to be used, attach the spacers to the paper flanges by reversing the abovementioned removal procedure as shown right. Spacer Paper flange CONNECTIONS PREPARATION 1 Attach the supplied paper flanges to both sides of the print paper. When you pinch the latches on the paper flange, the stoppers retract into the shaft. Attach the flanges to the print paper with the stoppers retracted. Make sure that the flanges are attached to the print paper securely, and release the latches. NOTE Take care not to pinch your fingers. Do not remove the sticker on the print paper yet. Any slack in the print paper may degrade the print quality. TROUBLESHOOTING · · · OTHERS · · NOTE When placing the print paper, remove one flange and keep the print paper upright on its side with no flange. When you put the print paper sideways, it may roll and fall. This may cause injury. Sticker CONTENTS NOTE Do not touch the thermal head. Fingerprints or dust on the thermal head will degrade the print quality. incorrect correct 12 BEFORE OPERATION 2 Press the POWER button to turn on the power. PRECAUTIONS 3 Press the DOOR OPEN button to open the door. Take the ink cassette in the printer out. FEATURES CONNECTIONS PREPARATION 4 Install the print paper into the unit. Make sure to install the print paper firmly. NOTE Install the print paper into the unit slowly. [. . . ] Cleaner pen FEATURES CONNECTIONS PREPARATION THERMAL HEAD CLEANING Clean the heat-generating part below the thermal head. Wipe the head cleaning part carefully with tissue paper dampened with a small amount of alcohol. NOTE · · Do not damage the thermal head. The thermal head is hot right after printing. [. . . ]