User manual MITSUBISHI CP9550DW

[. . . ] DIGITAL COLOR PRINTER MODEL CP9550DW OPERATION MANUAL POWER ALARM PAPER/INK RIBBON DATA READY COOLING DOOR OPEN CANCEL FEED&CUT THIS OPERATION MANUAL IS IMPORTANT TO YOU. PLEASE READ IT BEFORE USING YOUR DIGITAL COLOR PRINTER. This digital color printer complies with the requirements and other relevant provisions of the EC Directive 89/336/EEC, 73/23/EEC, 93/68/EEC and 1999/ 5/EC. The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. All places of operation are characterised by their connection to the public low voltage power supply system. INFORMATION This Class A digital apparatus complies with Canadian ICES-003. [. . . ] (page 13-14) INSTALLATION OF PRINT PAPER latches FEATURES Spacers 2 The spacers are attached to the paper flanges. For the necessity of the spacers, see the Quick Setup Guide. Remove the cushions put between the paper flange and spacer when use them. Turn the spacer until the latches are unlocked. Remove the spacer with the paper flange's stoppers retracted. When you use the print paper with which the spacers have to be used, attach the spacers to the paper flanges by reversing the abovementioned removal procedure as shown right. Spacer Paper flange CONNECTIONS PREPARATION 1 Attach the supplied paper flanges to both sides of the print paper. When you pinch the latches on the paper flange, the stoppers retract into the shaft. Attach the flanges to the print paper with the stoppers retracted. Make sure that the flanges are attached to the print paper securely, and release the latches. NOTE Take care not to pinch your fingers. Do not remove the sticker on the print paper yet. Any slack in the print paper may degrade the print quality. Sticker · · NOTE When placing the print paper, remove one flange and keep the print paper upright on its side with no flange. When you put the print paper sideways, it may roll and fall. This may cause injury. TROUBLESHOOTING · · · OTHERS CONTENTS INCORRECT NOTE Do not touch the thermal head. Fingerprints or dust on the thermal head will degrade the print quality. CORRECT 11 BEFORE OPERATION 2 Press the POWER button to turn on the power. PRECAUTIONS 3 Press the DOOR OPEN button to open the door. Take the ink cassette in the printer out. FEATURES CONNECTIONS PREPARATION 4 Install the print paper into the unit. Make sure to install the print paper firmly. NOTE Install the print paper into the unit slowly. If it is dropped along the ditches, the unit or accessories may be damaged. TROUBLESHOOTING Direction of paper insertion OTHERS 5 Remove the sticker, insert the print paper between the rollers as shown right, and feed the print paper until it reaches the black cover. · Remove the sticker before inserting the print paper between rollers. Dirt on the roller may degrade the print quality. Roller Print paper · CONTENTS · · · NOTE When taking the print paper out, pull it up toward you. Make sure to turn on the power before replacing the print paper. Make sure to eliminate any slack from the print paper. [. . . ] The thermal head is hot right after printing. Wait until the head temperature drops low before cleaning the thermal head. Cleaning part of thermal head TROUBLESHOOTING Inside 2 WHEN USING THE CLEANING RIBBON (CR9000) When you use print paper of 152 mm (6") with after using that of 127 mm (5"), thermal head cleaning with a cleaning ribbon may be required. If one or two lines appear on the printing surface as shown right when printing on the print paper of 152 mm (6") width, clean the thermal head using the optional cleaning ribbon. [. . . ]