User manual MITSUBISHI EY-3D-EMT1

[. . . ] Please read it before using your 3D Emitter. Contact your dealer if there is something wrong with your 3D Emitter. Do not operate if smoke, strange noise or odor comes out of your projector. In this case, contact your dealer immediately. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment. This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This symbol mark is according to the directive 2002/96/EC Article 10 Information for users and Annex IV, and/or to the directive 2006/66/EC Article 20 Information for end-users and Annex II. Your MITSUBISHI ELECTRIC product is designed and manufactured with high quality materials and components which can be recycled and/or reused. This symbol means that electrical and electronic equipment, batteries and accumulators, at their end-of-life, should be disposed of separately from your household waste. If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means that the battery or accumulator contains a heavy metal at a certain concentration. This will be indicated as follows: Hg: mercury (0, 0005%), Cd: cadmium (0, 002%), Pb: lead (0, 004%) In the European Union there are separate collection systems for used electrical and electronic products, batteries and accumulators. Please, dispose of this equipment, batteries and accumulators correctly at your local community waste collection/recycling centre. Information on Disposal in other Countries outside the European Union This symbol mark is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal. Environment care information for users in China This symbol mark is only valid in China. Using this 3D Emitter and the separately sold 3D Glasses (EY-3DGS-1U), you can enjoy viewing 3D images on Mitsubishi projectors supporting 3D images. For viewing 3D images or making the related settings, see the User Manual supplied with the projector. What's included in the box The transmission angle can be adjusted vertically in five steps. Connect this terminal to the 3D EMITTER terminal on the projector using the supplied mini DIN 5-pin cable. The transmission angle can be adjusted vertically in five steps by switching the angle of the transmission part. The above figures are approximate and may be slightly different from the actual measurements. [. . . ] After completing the adjustment, fix the 3D Emitter firmly using the supplied double-sided tape, etc. See the front of the 3D Emitter through a digital camera or a cell phone camera and check that the LEDs for infra-red transmission (9) are illuminated. The specifications and outside appearance are subject to change without prior notice. Anslut utrustningen till ett annat vägguttag än till det som mottagaren är anslutet till. [. . . ]