User manual MITSUBISHI EY-3DGS-1U

[. . . ] Supported projectors are subject to change without notice. * Mitsubishi DLPTM Link projectors supporting 3D images are excluded. For details about the 3D system, see the descriptions of the 3D in the User Manual supplied with the projector. Please read it before using your 3D Glasses. [. . . ] In this case, place the 3D Glasses and 3D Emitter as far from the fluorescent lights as possible or turn off the fluorescent lights. When you wear it upside down or back to front, you can not get the correct 3D images. Using the 3D Glasses, it may be hard to see other displays such as that of a personal computer, digital clock and calculator. Remove the glasses when you watch images other than 3D images. The 3D Glasses can not be used as sunglasses. This 3D Glasses can not be used with incompatible products. This 3D Glasses can not be used for movies in the movie theater. You can not get 3D images when you lie down, even when wearing the 3D Glasses. When using the device in Europe: COMPLIANCE NOTICE This device complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" and 2006/95/EC "Low Voltage Directive". The electro-magnetic susceptibility has been chosen at a level that gains proper operation in residential areas, on business and light industrial premises and on small-scale enterprises, inside as well as outside of the buildings. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Changes or modifications not expressly approved by Mitsubishi could void the user's authority to operate this equipment. This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This symbol mark is according to the directive 2002/96/EC Article 10 Information for users and Annex IV, and/or to the directive 2006/66/EC Article 20 Information for end-users and Annex II. Your MITSUBISHI ELECTRIC product is designed and manufactured with high quality materials and components which can be recycled and/or reused. This symbol means that electrical and electronic equipment, batteries and accumulators, at their end-of-life, should be disposed of separately from your household waste. If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means that the battery or accumulator contains a heavy metal at a certain concentration. [. . . ] The 3D Glasses stop working temporarily when the 3D Glasses can not receive the infra-red signal from the 3D Emitter by the reason such as turning your head away while watching 3D images. In this case, even when you turn around, you may see double images until 3D images restart, however it is not a malfunction. 3D Glasses automatically turn off 5 minutes after the infra-red signal from the 3D Emitter is interrupted. Is there any block in the communication area between the 3D Emitter and the 3D Glasses? [. . . ]