User manual MITSUBISHI G-50A

[. . . ] Mitsubishi Electric Air-conditioner Network System Central Controller Model: G-50A Contents 1. Initial setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 5-1 Shifting to initial setting menu . . . . . . . . . . . . 25 5-2 M-NET address setting . . . . . . . . . . . . . . . . . . . . . [. . . ] Operation mode selection, fan speed selection, air direction, etc. , can be collectively set regardless of the functions of the unit. However, actual setting to a unit without functions cannot be performed. To obtain the correct setting contents, refer to the respective group operation setting screens. -18- 4-3 Timer operation · A weekly schedule setting can be specified for each group. · Possible to set on the timer the schedule to prohibit operation of the local remote controller in addition to ON/OFF schedule. · Always set to current time on the current time setting screen when the schedule setting is performed. Refer to section "4-5 Current time setting". NOTE: When browser monitoring, or schedule setting from central monitoring PC, was performed, the timer screen of this function cannot be used. "This function is set from a higher level. " is displayed on this screen. <Schedule setting function summary> 1 The ON and OFF (PROHIBITION and PERMISSION) times can set in 10-minute units. 2 The daily operation schedule can include up to three ON (PROHIBITION) time settings and three OFF (PERMISSION) time settings. 3 Three types (P1-P3) of daily ON/OFF pattern and one type (P4) of prohibition/permission pattern are available respectively, each of which can be set every to each group. Week day which is not set in timer pattern is displayed with (-). In addition, it is also possible to set the schedule which has combined P1 -P3 and P4 together . ( P1 / P2 / P3 ) In this case, both of ON/OFF pattern and prohibition/permission pattern are daily executed. Any one of these options may be selected for each separate day of the week. 4 The schedule patterns can be copied easy to other group by the memory and memory read functions because the schedule contents can be recorded in the memory. 5 The setting temperature or set-back value setting can also be supported during timer operation. <Shifting to the schedule setting screen> Press the 3 switch to select "3 SCHEDULE SETTING". Press the switch to go back to the user operation menu screen. BACK SCREEN Press the switch to move the cursor position to P1 (or P2 or P3 or P4 ). (The "P1" indication blinking. ) And press the switch to the P1 (Pattern 1) Schedule pattern setting screen. ENTER · The schedule contents of each group can be monitor. · Weekly schedule pattern setting can be performed. Press the BACK SCREEN switch. · Schedule pattern (P1 P3 , P4 ) setting can be performed. -19- (1) Schedule pattern (P1 P3) setting · Follow the procedures described below to set each daily schedule pattern for each group. · The setting temperature or set-back values setting are also performed in the schedule setting operation. To enter the setting temperature or set-back value setting select SET-BACK or SET TEMP. Accordance with section "5-7 user setting (page 34)" in advance. [. . . ] · · Numeric keypayed : Move the cursor to the address setting position. : Set the address (0 255) -41- Appendix 2 : User operation (abridged) Shows the operation panel, screen, etc. Overall status lamp ON . . . During operation OFF . . . All group are stopping BLINKING. . . Malfunction Collective operation switch ON/OFF TEST RUN ON/OFF MODE 1 2 FAN SPEED 3 AIR DIRECTION 6 VENTILATION 9 INS. RESET DEL. GROUP SELECT BACK SCREEN 4 TEMP. [. . . ]