User manual MITSUBISHI GIFT KIOSK PRODUCT INFORMATION

[. . . ] WARNING Use the attached specified power supply cord. If you use another power supply cord, it may cause interference with radio and television reception. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION The attached power cord is to be used exclusively for this product. [. . . ] Select to enlarge and project images of Vista size. Select to enlarge to 16:9 and project of the images with an aspect ratio of 4:3. (Non-linearly stretched. ) This mode is suitable for viewing 2. 35:1-size images using the anamorphic lens. Use the p or q key to adjust the vertical display position. This mode doesn't support input signals from personal computers. This mode is suitable for viewing 16:9- or 4:3-size images or images input from personal computers using the anamorphic lens. Use to enable or cancel the password lock. Use to reduce the brightness of the menu. The film mode will be automatically activated when a film source signal is input. When flicker occurs on the screen or jaggies on slanting lines are remarkable, select FILM when a film source signal is input or select VIDEO for other signals. Sets the position of remote infrared receiver to front or rear. Use to display the black bar on the right half of the image. · Thoughhorizontalstripsmayappearontheenlargedprojectedimage, suchsymptomisnotamalfunction. · Whenyouchangethehorizontalorverticalpositiontoalargeextent, noisemayappear. · Theadjustablerangeoftheverticalpositionvariesdependingonthetypeoftheinputsignal. Thoughtheimage may stay in the same position even when the setting value is changed, such symptom is not a malfunction. · IfyouincreasetheOVERSCANsettingwhenviewingvideosignals, noisemayappearonthescreen. Inthiscase, decrease the OVER SCAN setting. · Whilea3Dsignalisbeingdisplayed, OVERSCANisfixedto100%. EN-34 Menu operation (continued) NETWORK menu opt. opt. NETWORK PROJECTOR NAME NETWORK PASSWORD IP CONFIG PJLink CERTIFICATION NETWORK RESET OK OK ON OK NETWORK IP CONFIG DHCP IP ADDRESS SUBNET MASK DEFAULT GATEWAY MAC ADDRESS ON 0. 0 XX-XX-XX-XX-XX-XX ITEM PROJECTOR NAME SETTING xxxxx. . . SET NETWORK PASSWORD IP CONFIG DHCP IP ADDRESS OK OK ON / OFF xxx. xxx SET MAC ADDRESS PJLink CERTIFICATION NETWORK RESET xx-xx-xx-xx-xx-xx ON / OFF OK FUNCTION Displays PROJECTOR NAME. Displays PROJECTOR NAME in blank when PROJECTOR NAME is not set. (See page 44. ) Set the name to identify the projector. Enter up to 15 characters (alphabets or numeric characters). [. . . ] If these problem persist, turn the projector off and consult your dealer. POWER indicator STATUS indicator Normal condition POWER STATUS Off Steady red CONDITION Stand-by Lamp stand-by for power-off Lamp stand-by for power-on The power is on. (Normal condition) NOTE Blinking green The power cannot be turned on by pressing the POWER button. The power cannot be turned off by pressing the POWER button. Blinking green Steady green Steady green Abnormal condition POWER Steady green or Blinking orange Steady red STATUS CONDITION Abnormal temperature · Theventilationgrillesarecloggedwithdustordirt. [. . . ]