User manual MITSUBISHI LVP-SD10U

[. . . ] Data Projector MODEL LVP-XD10U LVP-SD10U OPERATING GUIDE Thank you very much for purchasing this DLPTM Technology Projector. Please read this operating guide to ensure a correct use of the device. After reading this manual, keep it for future reference. Outline This DLPTM Technology Projector can display various computer signals and NTSC/PAL/ SECAM video signals. Features 1. Compact size, light weight for portability 4. [. . . ] Pressing this button displays a still (frozen) picture. Pressing this button partially magnifies a displayed picture. (Move the picture with the Disk Pad after pressing the Magnify button. ) When the OSD menu is active, Disk Pad acts as selecting device. When the on-screen menus are not active, it works as mouse pad. When the magnify function is active, use disk pad to move through the picture. The blank screen is displayed by pressing Blank. And the blank screen will be revealed partially from top to bottom by pressing Blank again. The sound gets louder or quieter by pressing the "+" or "-" button. When operating in the mouse emulation mode, it registers a left mouse click. When operating in the mouse emulation mode, it registers a right mouse click. To move Left/Right among OSD items. Menu Blank Source Mute Volume Laser Mouse Left-Click Mouse RightClick Exit Drag Inserting Batteries in the Remote Control Be sure to follow instructions in placing batteries into the remote control units. Push and slide the lid in the direction of the arrow. Install two `AAA' batteries as indicated inside the battery compartment. Replace the lid and snap it into place. Caution Avoid excessive heat and humidity. Do not mix new and old or different types of batteries. 10 English Figure 13 Battery replacement process Remote Control Range The range for operation is about 10 m (about 32 feet ) when the remote control points to the projector. The distance from the screen back to the projector must be less than 10 m (about 32 feet). Depending on the type of the screen, the distance will be different. Figure 14 Range Usage and Replacement of Lamp The light source lamp has a limited service life. The picture will become dark or the color will fade after the lamp has been used for a long time. In such cases, continued use of the lamp could cause a malfunction. Replace the lamp with a new one. A 1. Lamp/temperature Status LED Indicator Lamp in excess of service hours When the LED light is a continuous green, it means the lamp has exceeded 900 service hours. After this light appears, it is advisable to replace the projection lamp as soon as possible. 1. AND RESET THE LAMP TIMER" will be displayed on the screen if the lamp has been operated for 900 hours (see figure 15). English 11 2. THE POWER WILL TURN OFF AFTER 20 HOURS" will be displayed on the screen if the lamp has been operated for 980 hours. [. . . ] Lightly wipe the clean cloth over the lens. Affix the lens cover whenever the projector is not in use. Refer to Page 13. Follow these steps to clean the projection lens: English 21 C Troubleshooting TRY THESE SOLUTIONS Plug the power cord into the AC Inlet. Plug the power cord into the power Inlet. Wait two minutes after the projector has been turned off before turning the projector back on. [. . . ]