User manual MITSUBISHI LVP-X100A

[. . . ] LCD Projector Owner's Guide X100 MODEL LVP-X100A 1 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NOTE: SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. 2 F COMPLIANCE NOTICE OF FCC This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] In this case, adjust CLAMP. When the equipment (DVD player system, etc. ) with Y, Cb, Cr connectors is conRGB / Y, Cb, Cr nected to the PC-1 or PC-2 connector, select [Y, Cb, Cr]. Depending on the DVD player, the image may not be projected correctly with this projector. Horizontal position: Adjust the start position (the left end) using H-POS, and adjust the end position (the right end) using TRACKING. Vertical position: Adjust the start position using V-POS. · If you change the settings of the USER PRESETS, you must select MEMORY and press the ENTER button. · The projector is able to memorize 2 signals setting. When reached over 2, settings of the signals will be deleted in chronologic order. · By pressing the + button, you can change the setting among the default condition and memorized condition. 32 Advanced feature for presentation Cursor operation 1. · The default position where the cursor appears on the screen can be set by using this on-screen menu. The operation indicator will be illuminated. (The operation indicator will turn off if the remote control is not used for a period of five minutes. ) 3. Move the cursor by using the remote control. Press the START/STOP button to momentarily freeze the cursor movement. Press the CURSOR button to cause the cursor to disappear. The pen, eraser, color of the cursor trails and the width of the cursor icons appear on the screen. Select the pen icon, then press the SELECT button. · If necessary, change the color or width of the cursor trails by selecting the icon and pressing the SELECT button repeatedly. Position the cursor where you want the path to begin. Press and hold the SELECT button, moving the cursor to draw a path. Move the cursor to where you want the point of one corner of the square, and press the DOUBLE CLICK button. Move the cursor to where you want the point of the opposite corner and press the DOUBLE CLICK button again. For more square lines, repeat steps 1 and 2. [. . . ] · Lamp is no longer working. · Take the lens cap off. · Replace the lamp with a new one. · Turn on the connected equipment. · Select the correct source according to the equipment connected to this projector. No picture appears on the screen. · The equipment connected to this projector is not turned on. [. . . ]