User manual MITSUBISHI MB-S60A

[. . . ] HOME-THEATER TELEVISION MODELS 638 Series C10 Series OWNER'S GUIDE · · · For questions: - Visit our website at www. mitsubishi-tv. com. - Call Consumer Relations at 800-332-2119 for operational or connection assistance. For information on System Reset, please see the back cover. To order replacement or additional remote controls or lamp cartridges, visit our website at www. mitsuparts. com or call 800-553-7278. ® 2 CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN FCC Declaration of Conformity Product: Models: Responsible Party: Projection Television Receiver WD-60638, WD-65638, WD-73638 WD-60C10, WD-65C10, WD-73C10 Mitsubishi Digital Electronics America, Inc. [. . . ] Oils from your fingers may cause premature lamp failure. Hg = MERCURY THE LAMP INSIDE THIS PRODUCT CONTAINS MERCURY AND MUST BE RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance at www. eiae. org For assistance call 1(800) 332-2119 28 Appendices Appendix A: TV Care, continued Lamp-Cartridge Replacement Removing the Old Lamp Cartridge 1. Allow the 2. lamp to cool for at least one hour before proceeding. After the lamp has cooled, remove the cover of the lamp compartment, located on the back of the TV. Use a #2 (medium) Phillips screwdriver to loosen the screw securing the cover. Keep the screw and cover for re-installation With a medium Phillips screwdriver, loosen the two screws securing the lamp cartridge until they disengage from the mating threads. These are captive screws and cannot be separated from the lamp cartridge. Fully open the bag supplied with the replacement lamp and set the opened bag aside. Gently grasp the handle of the lamp cartridge and pull the old cartridge straight out. CAUTION: Do not tilt or rotate the cartridge, as small glass fragments may fall out. Without tilting or putting down the lamp cartridge, insert it into the opened bag. Close the bag while being careful not to let any glass particles fall out. Figure 1 Figure 2 3. 4. 5. Figure 3 Use only replacement lamp part number 915B441001. 6. Installing the New Lamp Cartridge 1. Do not touch the glass parts of the new lamp cartridge. Insert the new cartridge into the TV in the same orientation as the old cartridge. Push on the cartridge housing until it is fully seated. Gently tighten the screws with the screwdriver. Replace the plastic cover and retaining screws. WASH YOUR HANDS THOROUGHLY, AS THIS LAMP CONTAINS MERCURY. Disposal of the Old Lamp Cartridge Lamp under warranty: All lamps replaced under warranty must be returned to Mitsubishi. Use the return shipping label provided and send to Mitsubishi Digital Electronics, America, 625 Braselton Parkway, Suite 200, Braselton, GA 30517. IMPORTANT: Lamps found without defects will be returned and charged back to the sender. [. . . ] If the problem persists please arrange for warranty service. Contact your nearest authorized MITSUBISHI service center, whose name and address can be obtained from your MITSUBISHI dealer, by writing at the address provided below, calling MDEA at the 800-332-2119, or by using the support feature of our website at www. Mitsubishi-tv. com. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. [. . . ]