User manual MITSUBISHI P95

[. . . ] DIGITAL MONOCHROME PRINTER MODEL P95DW P95DE OPERATION MANUAL THIS OPERATION MANUAL IS IMPORTANT TO YOU. PLEASE READ IT BEFORE USING YOUR DIGITAL MONOCHROME PRINTER. DIGITAL MONOCHROME PRINTER This digital monochrome printer complies with the requirements of the EC Directive 93/42/EEC. FOR THE MODEL P91DW(UB) ONLY WARNING: In the USA or Canada, use the AC power cord according to the recommendations as below, in order to comply with UL60601-1 and CAN/CSA C22. 2 No. Connect to the 120V receptacle of the room or the host equipment. The AC power cord should be UL or CSA approved and consist of type SJT, size 16 or 18AWG, length 2. 5m or shorter cord with IEC60320-1/C13 type, 125V 10A or higher rating connector and NEMA 5-15 type, 125V 10A or higher rating, Hospital Grade plug. [. . . ] If the paper absorbs non-volatile organic solvents (alcohol, ester, katone, etc. ) the print may be discolored. Particularly, if the paper comes in contact with soft vinyl chloride such as a transparent tape, it quickens discoloration. Do not use paper other than the specified types. Immediately after the paper is replaced, 2-3 images may be printed with a blank part due to hand's dust or oil. Avoid direct sunlight or places near heaters, etc. , and store the paper in a place with 30°C (86°F) or lower temperature and 35-80% RH. When the paper is rapidly transferred from a cool place to a hot place, a vapor or a dew is generated on the paper surface causing paper jam or degraded printing quality. A finger print or dust on the paper surface may degrade the printing quality. Note: Mitsubishi brand thermal paper is specially treated with an anti-static coating against thermal head damage caused by static-electricity discharge. The use of non-treated paper may cause premature head failure in your product. 3 SAFETY TECHNICAL CHECKS Periods: According to the recommendations of the manufacturer of medical device. Scope: a) Visual check Housing, cables, operator controls, readout device (displays, LED etc. ), labels, accessories, instruction manual. instruction manual, also unity and applicability of set and accessory test. c) Electrical check Safety electrical test of the configuration in accordance with EN60601-1. " In the interest of safety, avoid the handling of liquids beside the set. " RESPONSIBILITY OF THE MANUFACTURER The manufacturer, assembler, installer or importer considers himself responsible for the effects on safety, reliability and performance of the EQUIPMENT only if: ­ assembly operations, extensions, re-adjustments, modifications or repairs are carried out by persons authorized by him, and ­ the electrical installation of the relevant room complies with the IEC requirements ­ the EQUIPMENT is used in accordance with the instructions for use. · Any service after expiration of the warranty period will be chargeable. Consult your dealer for advice. TECHNICAL DESCRIPTION The supplier will make available on request such circuit diagrams, component part lists, descriptions, calibration instructions or other information which will assist the USER's appropriately qualified technical personnel to repair those parts of the EQUIPMENT which are classified by the manufacturer as repairable. The use of ACCESSORY equipment not complying with the equivalent safety requirements of this equipment may lead to a reduced level of safety of the resulting system. Consideration relating to the choice shall include: ­ use of the accessory in the PATIENT VICINITY ­ evidence that the safety certification of the ACCESSORY has been performed in accordance to the appropriate EN60601-1 and/or EN60601-1-1 harmonized national standard. The transportation and storage environmental conditions are: Temperature : -20°C - +60°C (-4°F - +140°F) Humidity: 90%RH or less at 40°C (104°F) Atmospheric pressure : 50 kPa - 106 kPa Note : The above transportation environmental conditions indicate the storage environmental conditions during transport. 4 PRODUCT OUTLINE The digital monochrome printer P95DW/P95DE uses the thermal printing system. This printer is able to print digital grayscale images on the thermal paper. This printer is connected to a host computer via USB interface. Digital images such as CT, MRI, ultrasound, and CR images transmitted from the host computer is printed via USB interface. This printer creates prints electronically (mainly in image processing and printing processing), not optically or chemically. INTENDED USE The digital monochrome printer P95DW/P95DE is intended for use as a hard copy device for an image generated by a diagnostic imaging equipment. [. . . ] Repeat the steps - by 2 or 3 times, and print 1-2 sheets to verify the cleaning effect. Red mark Adjust the red mark on the cleaning paper parallel to the platen roller. Cleaning paper Platen roller CAUTION · It is recommended that after printing 10 rolls of paper the unit be cleaned using the supplied cleaning paper. · If the symptom of the dirty head is not corrected even after cleaning, your set needs repairing, contact your dealer. · Do not pull out the sheet and the cleaning paper while the door is closed. [. . . ]