User manual MITSUBISHI PK-10 POCKETPROJECTOR

[. . . ] LED Projector "Pocket" MODEL PK10 User Manual This User Manual is important to you. Please read it before using your projector. EN-1 EN-2 WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS AC ADAPTER'S PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET. NOTE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WHEN USING THE AC ADAPTER, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. EN-3 WARNING Only use the attached specified AC adapter and power cord. [. . . ] If the AC adapter is modified or altered, it may cause fire or electric shock. Caution: Plug in the power cord firmly. When unplugging, hold and pull the power plug, not the power cord. Do not plug in or out the power cord with your hand wet. Important: Install the screen on a flat wall at 90 degrees to the floor. Images may not be projected in a shape of a regular rectangle or with its aspect ratio 4:3, depending on the installation conditions of the projector and the screen. To correct vertical keystone distortion: On the optional remote control: press the KEYSTONE buttons. On the control panel: adjust KEYSTONE in the INSTALLATION menu. In the following cases: Press the KEYSTONE . Press the KEYSTONE . EN-18 Important: When the keystone adjustment is carried out, the adjustment value is indicated. Note that this value doesn't mean a projection angle. The allowable range of the adjustment value in the keystone adjustment varies depending on the installation conditions. When the keystone adjustment takes effect, the resolution decreases. In addition, stripes may appear or straight lines may bend in images with complicated patterns. They are not due to product malfunctions. Noise may appear on the screen during the keystone adjustment because of the type of the video signal being projected and the setting values of the keystone adjustment. In such cases, set the keystone adjustment values in the range where the image is displayed without noise. When the keystone adjustment is carried out, the image may not be displayed correctly because of the type of input signal. EN-19 Basic operation On the control panel 3 4 3 Power-on 1. Turn on the device connected to the projector first. Plug the AC adapter in both the projector and the wall outlet. The CHARGE indicator lights up when the projector connects with a not fully charged battery. The projector charges a not fully charged battery all the time. The projector stops charging battery when battery is fulled. Press the POWER button either on the control panel or the remote control. [. . . ] 1 Remote Control RM-PK10C 1 Lithium-ion Rechargeable Battery BT-PK10R 290P139-10 283P076-10 * Optional accessories Pin No 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Name R(RED)/CR G(GREEN)/Y B(BLUE)CB GND GND GND GND GND DDC5V GND GND DDC Data HD/CS VD DDC Clock EN-37 Pin assignment of S-Video, Video and VGA terminals 4 2 3 1 1 2 10 5 1 6 Pin No 1 2 3 4 Name GND GND Y C Pin No 1 2 Name GND Video In 15 11 Specification of RGB signals in each computermode of the projector Signal mode VGA 60 VGA 85 VGA mode3 MAC VGA VESA 72 VGA VESA 75 VGA VESA 85 VGA VESA 85 SVGA VESA 56 SVGA VESA 60 SVGA VESA 72 SVGA VESA 75 SVGA VESA 85 MAC 16 MAC 19 XGA VESA 60 XGA VESA 70 XGA VESA 75 XGA VESA 85 HP 75 SXGA VESA 70 SXGA VESA 75 Resolution (H x V) 640 x 350 640 x 350 640 x 480 640 x 480 640 x 480 640 x 480 640 x 480 720 x 400 800 x 600 800 x 600 800 x 600 800 x 600 800 x 600 832 x 624 1024 x 768 1024 x 768 1024 x 768 1024 x 768 1024 x 768 1024 x 768 1152 X 864 1152 X 864 Horizontal frequency (kHz) 31. 47 37. 86 31. 47 37. 86 37. 86 37. 50 43. 27 37. 93 35. 16 37. 88 48. 08 46. 88 53. 67 49. 72 60. 24 48. 36 56. 48 60. 02 68. 68 62. 94 64. 00 67. 50 Vertical frequency (Hz) 59. 94 85. 08 59. 94 72. 00 72. 80 75. 00 85. 01 85. 04 56. 00 60. 00 72. 00 75. 00 85. 06 74. 55 75. 02 60. 00 70. 00 75. 03 85. 00 74. 92 70. 02 75. 00 EN-38 Specification of HDTV signals Signal mode Resolution (H x V) 480i 480p 576i 576p 720p 60 720p 50 1080i 60 1080i 50 Important: 720 x480 720 x480 720 x576 720 x576 1280 x720 1280 x720 1920 x1080 1920 x1080 Horizontal frequency (kHz) 15. 80 31. 50 15. 60 31. 30 45. 00 37. 50 33. 80 28. 10 Vertical frequency (Hz) 60. 00 60. 00 50. 00 50. 00 60. 00 50. 00 60. 00 50. 00 Some computers aren't compatible with the projector. The projector's maximum resolution is 800 x 600 pixels. It may not display images of higher resolutions than 800 x 600 correctly. Images with SYNC on G (Green) signal may jitter. [. . . ]