User manual MITSUBISHI PMFY-NBMU-E

[. . . ] Use the attached RGB cable and RS-232C cable with this equipment so as to keep interference within the limit of a FCC Class B device. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/ Data Processing Equipment, ANSI/NFPA 75. When using the projector in Europe: COMPLIANCE NOTICE This projector complies with the requirements of the EC Directive 2004/108/EC "EMC Directive" and 2006/95/EC "Low Voltage Directive". [. . . ] (See page 33. ) Use to correct smeared color boundaries. For analog signal input: The input level of video signal differs among devices to be connected. High input level causes solid white in displayed image and low input level causes displayed image to get dark. Use this menu to adjust the input level of analog video signal. For digital signal input: AUTO / AUTO: The proper setting is automatically selected. ENHANCED / ENHANCED: Select when solid black occurs. NORMAL NORMAL: Select when grayish black occurs. (See page 16. ) AV MEMORY SAVE 3 options Select the AV MEMORY to which you save the current setting. (See page 30. ) · By using the AV memory function, you can save up to 3 setting patterns of IMAGE menu for each input terminal. (See page 30. ) · INPUT LEVEL is unavailable when the digital signal is supplied from the YCBCR/YPBPR terminal of the connected device. EN-26 Menu operation (continued) 2. INSTALLATION menu opt. INSTALLATION KEYSTONE LAMP MODE AUTO POWER ON AUTO POWER OFF SPLASH SCREEN BACK COLOR IMAGE REVERSE TRIGGER OUT TEST PATTERN LENS LOCK AV MEMORY 1 0 STANDARD OFF OFF ON BLUE OFF OFF CROSS HATCH OK ON 2. · When the lamp mode is switched, the projected image may flicker. · Do not change the setting of LAMP MODE frequently. · To cancel the test pattern, press any button. EN-27 Menu operation (continued) 3. FEATURE menu opt. FEATURE ASPECT PASSWORD FUNCTION MENU POSITION MENU DIMMER CINEMA MODE ? AV MEMORY 1 AUTO DISPLAY INPUT 1. OFF AUTO AUTO AUTO OFF English OK VIDEO SIGNAL SETUP SCART INPUT AË LANGUAGE RESET ALL 3. FEATURE menu ITEM ASPECT SETTING AUTO 4:3 16:9 ZOOM1 ZOOM2 STRETCH ANAMORPHIC1 FUNCTION Select to change the aspect ratio automatically depending on the input signal. Select to project images with an aspect ratio of 4:3. Select to project images with an aspect ratio of 16:9. (Linearly stretched. ) Select to enlarge and project images of CinemaScope size. Select to enlarge and project images of Vista size. Select to enlarge to 16:9 and project of the images with an aspect ratio of 4:3. [. . . ] Important: · Some computers aren't compatible with the projector. · The projector's maximum resolution is 1920 x 1080 pixels. It may not display images of higher resolutions than 1920 x 1080 correctly. · If the resolution and frequency of your computer aren't shown on the table, find the compatible resolution and frequency by changing the resolution of your computer. · This projector doesn't support 480p signals from video devices having 4 lines (R, G, B, CS*) or having 5 lines (R, G, B, H, V). [. . . ]