User manual MITSUBISHI S50

[. . . ] LCD Projector User Manual S50 MODEL LVP-S50U EN ­ 1 ESPAÑOL ITALIANO DEUTSCH FRANÇAIS ENGLISH CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NOTE: SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. WARNING Use the attached specified power supply cord. If you use another power-supply cord, it may cause interference with radio and television reception. [. . . ] The sharpness becomes TINT 0 sharper as the number increases. The color balance of the image shifts green as the number increases and shifts to purple as the number decreases (displays only when the source is selected to VIDEO). · When the TV50 (PAL, SECAM) signal is inputted, you cannot adjust the TINT. Adjusts the color intensity of the image (displays only when the source is selected to VIDEO). Opt 2 INSTALLATION IMAGE REVERSE Use to reverse or invert the projected image. MIRROR INVERT is effective XGA60 when the projector is ceiling-mounted. To select whether to boot up automatically when the power is INSTALLATION IMAGE REVERSE OFF turned on external to the projector. In this case, the main AUTO POWER ON OFF power switch of the projector has to be ON. Set this when the AUTO POWER OFF OFF projector is hanging on the ceiling. · The projector is in stand-by mode when the lamp is not on. In this case, use the remote control to turn on the lamp. Use to select the length of time before projector switches to stand-by when there is no input signal selected source. to cancel this function. Opt 3 FEATURES MENU POSITION . Use to select the position where the menu is displayed, XGA60 (upper left) or (lower right). FEATURE EXPAND MODE Selects the mode of enlarging screen. Select 1 (COMPUTER mode) to output the sound which is A EXPAND MODE 1. inputted to audio input terminal only when the source is AUDIO MODE 2 selected to COMPUTER. VIDEO SIGNAL AUTO the sound which is inputted to audio input terminal only ANAMORPHIC OFF when the source is selected to VIDEO . Select 3 LANGUAGE English Ë (PARMANENT mode) to output the sound which is inputted to audio input terminal all time. Use to display the splash screen on the screen when the power is turned ON. When AUTO is set, the appropriate video format is automatically selected according to the input signal. If the image does not appear correctly, select the desired video format manually. Adjust the projector to the appropriate format when the projector either is not projecting normally in auto mode or is projecting PAL-M/PAL-N signals. [. . . ] · Install the projector far away from other equipment. · Turn on the monitor. · Press the reset button on the Terminal board. See page 15. EN ­ 25 Indicators The projector has three LED Indicators which shows the working condition of the projector. The following offers solutions to possible problems. [. . . ]