User manual MITSUBISHI WD-62627

[. . . ] Projection Television Models WD-52627, WD-62627 Owner's Guide TM TM TM TV Information: Use this space to record the model and serial numbers of your television. This information is on the back of your TV Model number Serial number visit our website at www. mitsubishi-tv. com CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user of the presence of uninsulated "dangerous voltage" within the product's enclosure that may be sufficient magnitude to constitute a risk of electric shock. [. . . ] The message, The recording has been added to the Record List will display. To view, change or cancel a recording, use the Record List (page 57). GUIDE and ChannelView Figures 11 and 12 ChannelView is available for antenna inputs not associated with TV Guide. Press GUIDE while viewing ANT-1 or ANT-2 to display a list of available memorized digital channels (D) and analog (A) channel information (if available from the broadcaster). This list is called ChannelViewTM ChannelView for digital channels will show the major and sub-channels (or bitstreams). Analog channel information will display as sent. Press ADJUST or to scan through the all the channels in memory one by one. To cycle through the choices quickly, press CH or . For detailed program information, press ADJUST , to return to basic information press ADJUST . This information is sent by the broadcaster. If limited data is shown or no program data appears, it is because the broadcaster is not sending the information. This is not a defect of your TV. Figure 12. ChannelView screen, future programs F i 11. Forg u r e complete ChannelView information to be refreshed daily, the TV must be powered Off from 5 to 15 minutes a day, depending on the number of channels in memory. If the TV loses power, the program listings will be temporarily lost. IMPORTANT Chapter 4. IEEE 1394 Devices and NetCommand-Controlled Recordings 59 NetCommand®-Controlled Recordings Setting up Recordings Figure 13 Recording Now Through NetCommand, you can automatically start and stop recordings and send signals from one playback device to a recording device. Recordings can be made on recordable devices connected to the TV. The TV can convert digital channels and IEEE 1394 device signals to analog signals that can be recorded on NetCommand compatible analog VHS and S-VHS VCRs You can schedule the recording to take place at a later time and program the recording duration for a minimum of 30 minutes and a maximum of 6 hours (in 30 minute increments). During the recording, the TV can be powered Off. If the TV is powered On, it will be tuned to the source that is being recorded. The TV should remain on this source to ensure the recording continue without interruption. Can be used when viewing Antenna 1 or 2, an IEEE 1394 device, or a non-recording traditional device. To initiate recording now: 1. In the "Record to" section, review the destination device and duration. Press a second time and the recording will start. Time-Delayed Recording 1. [. . . ] If the problem persists please arrange for warranty service. Contact your nearest authorized MITSUBISHI service center, whose name and address can be obtained from your MITSUBISHI dealer, by writing at the address provided below, calling MDEA at the 800-332-2119, or by using the support feature of our website at www. Mitsubishi-tv. com. Warranty service will be provided in your home or, if required, at an authorized service shop, provided that your television is located within the geographic territory customarily covered by an authorized MITSUBISHI service center. If not, you must either deliver your television to an authorized service location at your own expense, or pay for any travel and/or transportation costs the service center may charge to and from your home. [. . . ]