User manual MITSUBISHI X70U

[. . . ] LCD Projector User Manual X50 X70 MODEL LVP-X50U / LVP-X70U EN ­ 1 ESPAÑOL ITALIANO DEUTSCH FRANÇAIS ENGLISH CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. NOTE: SINCE THIS PROJECTOR IS PLUGGABLE EQUIPMENT, THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE. WARNING Use the attached specified power supply cord. If you use another power-supply cord, it may cause interference with radio and television reception. [. . . ] For AUTO POWER ON OFF normal use, select 0°. To select whether to boot up automatically when the power is turned on external to the projector. In this case, the main power switch of the projector has to be ON. Set this when the projector is hanging on the ceiling. · The projector is in stand-by mode when the lamp is not on. In this case, use the remote control to turn on the lamp. Use to select the length of time before projector switches to stand-by when there is no input signal selected source. to cancel this function. Opt 3 FEATURES MENU POSITION . Use to select the position where the menu is displayed, XGA60 (upper left) or (lower right). FEATURE EXPAND MODE Selects the mode of enlarging screen. Select 1 (COMPUTER mode) to output the sound which is 2 inputted to audio input terminal only when the source is ?AUDIO MODE VIDEO SIGNAL AUTO selected to COMPUTER. Select 2 (VIDEO mode) to output ANAMORPHIC OFF the sound which is inputted to audio input terminal only LANGUAGE English Ë when the source is selected to VIDEO . Select 3 (PARMANENT mode) to output the sound which is inputted to audio input terminal all time. Use to display the splash screen on the screen when the power is turned ON. When AUTO is set, the appropriate video format is automatically selected according to the input signal. If the image does not appear correctly, select the desired video format manually. Adjust the projector to the appropriate format when the projector either is not projecting normally in auto mode or is projecting PAL-M/PAL-N signals. Set to ON when displaying DVD discs which are recorded as squeezed images (in right and left direction). Use to select the language for the projector display such as menu. ( / English / Español / Deutsch / Français / Italiano / ) Opt A A A A EN ­ 16 4 SIGNAL MEMORY CALL . . . . . . . . Use to adjust the horizontal position of the image. [. . . ] · Turn on the monitor. · Press the reset button on the Terminal board. See page 15. EN ­ 25 Indicators The projector has three LED Indicators which shows the working condition of the projector. The following offers solutions to possible problems. If a problem persists, turn the projector off and consult your dealer. AUTO POSITION POWER indicator POWER COMPUTER MUTE LAMP indicator LAMP VOLUME SOURCE VIDEO MENU ENTER TEMP indicator TEMP Normal condition POWER LAMP TEMP Steady red CONDITION Stand-by Lamp stand-by (about for 1 minute) The POWER is ON. [. . . ]