User manual MOFFAT GSC5061S

[. . . ] GAS COOKER GSC 5061 GB 2 CONTENTS Instructions for the user Important Safety Information Description of the appliance Technical Features Using the appliance - Using the oven - Hints & Tips - Using the Grill - Using the Hob Maintenance and Cleaning Something Not Working Service & Spare Parts Customer Care Guarantee conditions 4 5 6 7 7 9 10 11 13 Conversion of gas 15 16 16 17 24 Instructions for the installer Safety Advice Technical Data Installation - Positioning - Ventilation - Location Gas connections - Electrical connection 18 19 19 19 20 20 21 23 How to read the instruction book The symbols below will guide you when reading the instruction book Safety instructions Step by Step Operation Advice and recommendations Environmental Information 3 IMPORTANT SAFETY INFORMATION You MUST read these warnings carefully before installing or using the appliance. If you need assistance, contact our Customer Care Department on 08705 950950. Installation · This cooker must be installed by qualified personnel, according to the manufacturer's instructions and to the relevant British Standards. · Any gas installation must be carried out by a registered CORGI installer. [. . . ] Before cleaning, ensure all control knobs are in the OFF position, and the appliance has cooled completely. Before any maintenance or cleaning can be carried out, you must DISCONNECT the cooker from the electricity supply. Cleaning materials Before using any cleaning materials on your oven, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives should also be avoided. Removing the Oven Door 1. Turn the two locking levers (1) on the hinge arms fully upwards. Hold the oven door at the sides using both hands and close the door partially to a 30o angle. Lift the door and pull out. External cleaning Regularly wipe over the control panel, oven door and door seal using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. To prevent damaging or weakening the door glass panels avoid the use of the following: · Household detergent and bleaches · Impregnated pads unsuitable for non stick saucepans · Brillo/Ajax pads or steel wool pads · Chemical oven pads or aerosols · Rust removers · Bath/Sink stain removers Hanging the Oven Door 1. Hold the oven door at the sides using both hands and hold the door at an angle of approx 30o. Introduce and then push the hinges into the cut-outs on the front of the oven, ensuring that the supports (2) of the hinge arms are correctly placed in the cut-outs (3) of the hinge support. Turn the locking levers (1) fully downwards. Oven Cavity The enamelled oven cavity is best cleaned whilst the oven is still warm. Wipe the oven over with a soft cloth soaked in warm soapy water after each use. From time to time it will be necessary to do a more thorough cleaning, using a proprietary oven cleaner. Oven Door Glass The internal oven door glass can be removed for cleaning. For this purpose remove the 2 fixing screws. Clean the outer and inner door glass using warm soapy water. Should the inner door glass become heavily soiled it is recommended that a cleaning product such as Hob Brite, or Bar Keepers Friend be used. Always support the door while removing the glass panel as the door may spring closed due to its lighter weight. 13 DO NOT clean the oven door while the glass panels are warm. If this precaution is not observed the glass panel may shatter. If the door glass panel becomes chipped or has deep scratches, the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Contact your local Service Centre who will be pleased to advise further. IMPORTANT: The inner door glass must be in place when using the oven. Hob After every use wipe with a soft cloth well wrung out in warm water to which a little washing up liquid has been added, avoiding any leakage through the holes of the hob. To remove more stubborn stains, wet and leave to dissolve, do not scratch and avoid the use of abrasive or caustic products that could damage the enamel. Burner cap Burners The burner caps and crowns can be removed for cleaning. [. . . ] · For LPG screw completely the by-pass screw. Reassemble the parts following the same procedure in reverse. Check that, when turning the knob quickly from the maximum position to the minimum one, the flame does not go out. 24 Stick the label supplied with the appliance (in the nozzles bag) corresponding to the gas type utilised. Replace the nozzles of the oven burners Oven burner To replace the gas oven nozzle, follow this procedure: · Check the table no. 1 for diameter of nozzle; · Remove the oven removable base panel; · Remove the screw on the oven burner rod at the rear of the oven; · Remove the oven burner by pushing it backwards. [. . . ]