User manual MOFFAT MGH621X

[. . . ] When in use a gas cooking appliance will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose. When using the hob for a long period time, the ventilation should be improved, by opening a window or increasing the extractor speed. Do not use this hob if it is in contact with water. [. . . ] after cleaning. 5 Instructions for the Installer This hob must be installed by qualified personnel to the relevant British Standards. Any gas installation must be carried out by a registered CORGI installer. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Engineers technical data Overall dimensions Width: 580 mm. Cut out dimensions Width: Depth: 550 mm. 470 mm. Supply connections Gas: RC 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V ~ 50 Hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse. Rear Left Burner (semi-rapid) Heat Input 2. 0 kW (6824 BTU/HR) Front Left Burner (rapid) Heat Input 3. 0 kW (10236 BTU/HR) 2. 8 kW L. P. G. (9554 BTU/HR) Rear Right Burner (semi-rapid) Heat Input 2. 0 kW (6824 BTU/HR) Front Right Burner (auxiliary) Heat Input 1. 0 kW (3412 BTU/HR) APPLIANCE CLASS: 3 APPLIANCE CATEGORY: II 2H3+ APPLIANCE GAS SUPPLY: Natural gas G20 (2H) / 20mbar Burner Dia. Tap By-pass 1/100 mm 28 32 40 Auxiliary Semi-rapid Rapid Aeration adjustment none 6 Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). 700 mm FITTING THE GAS HOB WITHOUT A COOKER HOOD ABOVE Provision for ventilation Detailed recommendations are contained in the following British Standards Codes Of Practice: B. S. The hob should not be installed in a bed sitting room with a volume of less than 20 m3. If it is installed in a room of volume less than 5 m3 an air vent of effective area of 110 cm2 is required. If it is installed in a room of volume between 5 m3 and 10 m3 an air vent of effective area of 50 cm2 is required, while if the volume exceeds 11 m3 no air vent is required. However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m3 and 11 m3. If there are other fuel burning appliances in the same room, B. S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. 400 mm 55 mm 50 m m 400 mm 100 mm 50 m m FO 0812 FITTING THE GAS HOB WITH A COOKER HOOD ABOVE 600 mm Location The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom, shower room or garage. Before making the cut out in the worktop ensure that the edges of the hob that are to be near either a side or rear wall have a minimum distance of 55 mm. between the edge of the hob and the wall. The minimum distance combustible material can be fitted above the hob is 400 mm. must be allowed from the edges of the hob. The minimum distance combustible material can be fitted directly above the hob is 700 mm. must be left between the side edges of the hob and any adjacent cabinets or walls. 650 mm 400 mm 50 m 55 m mm 400 mm 100 mm 50 m m FO 0813 7 Installation When the hob is first installed Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. On the end of the shaft, which includes the GJ 1/2" threaded elbow, adjustment is fixed so that the washer is fitted between the components as shown in the diagram. Screw the parts together without using excessive force. FO 0814 FO 0264 Gas Connection Connection to the gas supply should be with either rigid or semi-rigid pipe, i. e. The connection should be suitable for connecting to RC 1/2 (1/2 BSP male thread). When the final connection has been made, it is essential that a thorough leak test is carried out on the hob and installation. [. . . ] * Appliances found to be in use within a commercial or similar environment, plus those which are the subject to rental agreements. * Products of Moffat manufacture which are not marketed by Moffat. 08705 929 929 Your call will be routed to the Service Centre covering your post code area. The addresses of Service Force Centres are detailed on the following pages. CUSTOMER CARE For general enquiries concerning your Moffat appliance and for further information on Moffat products, contact our Customer Care Department by letter or telephone as follows: Customer Care Department Moffat 55-77 High Street Slough Berkshire SL1 1DZ Tel : 08705 950950 * calls to this number may be recorded for training purposes European Guarantee This appliance is guaranteed by Electrolux in each of the countries listed below for the period specified in the appliance guarantee or otherwise by law. [. . . ]