User manual MONITOR AUDIO RADIUS FLOORSTAND ASSEMBLY INSTRUCTIONS

[. . . ] Thank you and congratulations on purchasing our bespoke Monitor Audio Radius Floorstand. This product has been designed using the most up-to-date computer technology to provide you with an aesthetically pleasing stand for your loudspeakers, and also to ensure that the exceptional sound quality is maintained. [. . . ] Simply leave the serial number section blank and fill in the model name/number section with `Radius Floorstand' ASSEMBLY INSTRUCTIONS 1. Now that you have removed the carton, remove the polystyrene end-caps to reveal your Radius Floorstands. While the Floorstands are lying on the floor, now is the time to put the spikes in (if you decide to use them), if you aren't using the spikes move on to Step 3. This is done by screwing them all the way into their threaded holes. Position the stands in their desired locations to see if they are level. If the stand does not appear to be level, unscrew one of the spikes slightly until the stand is level and tighten up the lock nut. You are now ready to fix your Radius Loudspeakers to the stand. Monitor Audio 2004 Radius Floor Stand Fixing Instructions 1 3. Take either your Radius 90 or Radius 180, remove the small red and black plastic caps from the terminals. A knife or fine blade screwdriver may be required to lever these out (Fig. Remove the screws located either side of the terminal on the back (labelled `A' and `B' in fig. These can be removed with the hex key provided with your stand. Place the Radius loudspeaker fixing screws into their holes in the back of the stand (Fig. [. . . ] 6), or if you are using bare wire terminations, unscrew the terminal slightly and placing your cable into the through hole and then tighten the terminal up again to hold the cable in place (Fig. Connect the speaker cable to your amplifier. Monitor Audio 2004 Radius Floor Stand Fixing Instructions 2 Fig. [. . . ]