User manual MONITOR AUDIO VECTOR VW-8

[. . . ] A polarised plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wider blade or the third prong are provided for your safety. If the provided plug does not fit your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] The table below can be used to set the frequency. this feature controls the upper frequency limit of the VW-8. The table below will help you to select the correct frequency at which to crossover depending on your main speakers. The LED indicates whether the unit is in stand-by mode or operational. It will be illuminated red when in stand-by, and green when operational. The logo badge on the front of the cabinet will also illuminate red and green depending on operational state. This control allows the subwoofer level or loudness to be adjusted in order that you can achieve a totally controlled, balanced sound. This is the only method of signal input connection to the VW-8. When using a stereo amplifier system, connection can be provided by a pair of high-quality signal cables from the pre-out section of an amplifier. If a digital AV processor or AV receiver/amplifier is to be used, a single cable can be connected from the `sub out' or LFE connection on the amplifier to the RCA input connection on the VW-8 labelled `R'. The RCA input marked `L' in this case will remain unused. Note: - cable lengths should not exceed 10 metres to avoid interference from other electrical appliances. See warning information on page 3 The Mains Power Switch should be switched to the `Off' position when the VW-8 will not be used for extended periods. the switch must be in the `On' position for the subwoofer to function. WARNING: Due to the mains switch being located on the rear panel, the apparatus must be located in the open area with no obstructions to access the mains switch. the VW-8 is supplied with a two-pin mains input socket for connection to the mains supply. Use ONLY the appropriate IEC mains lead provided with the product. If this fuse blows during operation a spare fuse is provided within the fuse holder for replacement. If you wish to change the fuse, you can do this by removing the IEC mains lead and carefully levering out the original fuse from its holder below the IEC mains input socket (10a). If the fuse blows again it is advisable to seek help from an authorised service agent. DO NOT attempt to re-fit a further fuse as this could result in serious damage to the amplifier unit. This is factory set to your country's mains voltage specification. [. . . ] To validate your warranty please visit www. When you register here you'll gain free entry to our monthly prize draw!What's more you'll be the first to hear about the great things happening at Monitor Audio, including new products and events!This equipment has been fully tested prior to dispatch from the factory. [. . . ]