User manual MORLEY PEDALS ABYOLDES

[. . . ] With common sense handling, it should last for years. We know you will appreciate the rugged construction of your Morley®. Most of all, we hope you enjoy using it as much as we enjoyed building it. THANK YOU! OPERATION This 6 way Multi-Channel Volume Pedal has been specially designed for gradual volume increases as the pedal is moved from off (toe up) to mid-travel (halfway between toe up and toe down). [. . . ] Most of all, we hope you enjoy using it as much as we enjoyed building it. THANK YOU! OPERATION This 6 way Multi-Channel Volume Pedal has been specially designed for gradual volume increases as the pedal is moved from off (toe up) to mid-travel (halfway between toe up and toe down). From mid -travel to full on (toe down) the volume increases faster. This audio taper combination gives you majestic volume swells great for pedal steel effects - when using the full pedal travel (toe up or toe down) or subtle volume change with slight pedal movement. The pedal should be plugged into your signal chain directly after your instrument and before devices that add gain (such as preamps, distortion and overdrive effects). Plugging into the pedal after these type of effects may result in unwanted volume in the "off" position. NOTE: How fast you move the pedal affects how the volume increases. The slower you move the pedal, the smoother the volume increases. · FEATURES Minimum Volume Control: This allows you to adjust your pedal as if it were specifically made for you. We'll give you two examples of how this control can be used. FULL (counter-clockwise) spreads the volume control out over the entire pedal sweep. The end result will be a pedal that comes on very slowly at first and then increases towards the middle and end of the sweep. SHORT (clockwise) makes the pedal come on a bit sooner for more traditional type volume swells. Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the Volume without unwanted noise typical with potentiometer (pot) controlled pedals. LED WAH On/Off Indicator: A red LED located above the Minimum Volume knob serves as a power on/off indicator. BATTERY REPLACEMENT Low or fluctuating output levels and/or a dim LED power indicator are signs of weak batteries. To avoid poor performance, replace the batteries when these signs appear. Slide the battery door located on the underside of the pedal to expose batteries. [. . . ] LED WAH On/Off Indicator: A red LED located above the Minimum Volume knob serves as a power on/off indicator. BATTERY REPLACEMENT Low or fluctuating output levels and/or a dim LED power indicator are signs of weak batteries. To avoid poor performance, replace the batteries when these signs appear. Slide the battery door located on the underside of the pedal to expose batteries. [. . . ]