User manual MORLEY PEDALS BCV-ST2

[. . . ] Most of all, we hope you enjoy using it as much as we enjoyed building it. OPERATION The Volume Mode has been specially designed for gradual volume increases as the pedal is moved from off (toe up) to mid-travel (halfway between toe up and toe down). From mid -travel to full on (toe down) the volume increases faster. [. . . ] This audio taper combination gives you majestic volume swells - great for pedal steel effects when using the full pedal travel (toe up or toe down) or subtle volume change with slight pedal movement. The pedal should be plugged into your signal chain directly after your instrument and before devices that add gain (such as preamps, distortion and overdrive effects). Plugging into the pedal after these type of effects may result in unwanted volume in the "off" position. NOTE: How fast you move the pedal affects how the volume increases. The slower you move the pedal, the smoother the volume increases. The WAH mode is activated by pushing the WAH switch (a red LED will light when it's "on") . With this new series, we've maintained the full, thick sound and wide bandwidth of previous Morley WAH pedals and added more reactive sound. BATTERY REPLACEMENT When the battery becomes weak, the overall wah will become weak and your signal may become slightly distorted. Remove the battery door located on the bottom of the pedal (a short cord is attached to the door to help prevent loss) Once the door is off, the old battery can be removed from the battery snap and new battery plugged in. Make sure the polarity (+/-) is correct before inserting the new battery. When you replace the battery door , you will notice it fits very tightly against the battery. This prevents the battery from rattling inside the pedal. WARRANTY All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service contact the store where purchased, or call 1-800-639-4668. [. . . ] To obtain warranty service contact the store where purchased, or call 1-800-639-4668. SPECIFICATIONS POWER: 9 Volt Battery or 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 6. 5 mA @ 9 VDC WAH mode 2. 5 mA @ 9 VDC Volume mode WEIGHT: 2. 9 lb. / 1. 32 kg INDICATOR: Wah mode LED on Bypass mode LED off Here is a general recommendation for hooking up a WAH with other effects: NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · WAH level Control: This knob controls the overall output level of the WAH effect. It does not change the wah sweep or range · WAH On/Off Switch: This switch turns the WAH effect "on" or "off". [. . . ]