User manual MORLEY PEDALS BCV-STES

[. . . ] With common sense handling, it should last for years. We know you will appreciate the rugged construction of your Morley®. [. . . ] Most of all, we hope you enjoy using it as much as we enjoyed building it. OPERATION The Wah Mode is activated by pushing the Wah switch. The Power Wah is equipped with true bypass. This means that when the pedal is in bypass mode, your original guitar signal is uninterrupted. We've maintained the full, thick sound and wide bandwidth of previous Morley WAH pedals and added more reactive sound. Now you can make your guitar talk and sing similar to the sounds of Hendrix, Clapton and other wah wah masters. When the pedal is not used for extended periods, we recommend you remove the battery from the pedal or replace it every six months to prevent leakage problems. SPECIFICATIONS POWER: 9 Volt Battery or 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 5 mA @ 9 VDC WEIGHT: 2. 9 lb. / 1. 32 kg Here is a general recommendation for hooking up a WAH with other effects: BATTERY REPLACEMENT When the battery becomes weak, the overall wah will become weak and your signal may become slightly distorted. Remove the battery door located on the bottom of the pedal (a short cord is attached to the door to help prevent loss). Once the door is off, the old battery can be removed from the battery snap and a new battery plugged in. Make sure the polarity (+/-) is correct before inserting the new battery. When you replace the battery door, you will notice it fits very tightly against the battery. This prevents the battery from rattling inside the pedal. · NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · WAH On/Off Switch: This switch turns the WAH effect "on" or "off". · Electro-Optical: The light from an LED (Light Emitting Diode) shines on an LDR (Light Dependent Resistor) and is controlled by a shutter placed between the two devices. [. . . ] When you replace the battery door, you will notice it fits very tightly against the battery. This prevents the battery from rattling inside the pedal. · NOTE: This pedal is not intended for use through an effects loop (send and return). FEATURES · WAH On/Off Switch: This switch turns the WAH effect "on" or "off". · Electro-Optical: The light from an LED (Light Emitting Diode) shines on an LDR (Light Dependent Resistor) and is controlled by a shutter placed between the two devices. [. . . ]