User manual MORLEY PEDALS BFW1

[. . . ] We know you will appreciate the rugged construction of your Morley®. Most of all, we hope you enjoy using it as much as we enjoyed building it. THANK YOU! AC ADAPTER Use Morley's 9VDC 300 milliamp regulated adapter only. [. . . ] Using a non-regulated adapter could cause a low frequency hum in your amplifier. Using the wrong polarity may damage the pedal. WARRANTY All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service contact the store where purchased, or call 1-800-639-4668. BATTERY The PWA-SS is designed to use one 9 volt battery when not using an adapter. We suggest you use a good quality alkaline battery. To prolong battery life, unplug your cord completely from the input jack when not using the pedal. When the pedal is not used for extended periods, we recommend you remove the battery from the pedal or replace it every six months to prevent leakage problems. SPECIFICATIONS POWER: 9 Volt Battery or 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 10 mA @ 9 VDC WEIGHT: 3. 0 lb. / 1. 36 kg INDICATOR: Wah mode LED on INPUT IMPEDANCE: Greater than 100K ohms OUTPUT: Will accept loads more than 10K ohms OPERATION The Wah Mode is activated by pushing the Wah switch (a red LED, located above the WAH switch, will light when it's "on"). With this new Pro Series pedal, we've maintained the full, thick sound and wide bandwidth of previous Morley WAH pedals. WAH On/Off Switch: This switch turns the WAH effect "on" or "off". In the "off" mode the pedal is in bypass. Electro-Optical: The amount of light from the LED (Light Emitting Diode) that shines on the LDR (Light Dependent Resistor) is controlled by a shutter placed between the two devices. Our unique electro-optical design ensures smooth overall control of the WAH without unwanted noise typical with potentiometer (pot) controlled pedals. Silent Switching: To further enhance the noiseless operation of our switchless design, we've added FET silent switching. Offering smooth and quiet transition between Wah and Bypass modes, absent of the pops and clicks associated with standard foot switches, this is ideally suited for studio recording and live performances. LED WAH On/Off Indicator: A red LED located above the WAH switch serves as on on/off indicator. [. . . ] Offering smooth and quiet transition between Wah and Bypass modes, absent of the pops and clicks associated with standard foot switches, this is ideally suited for studio recording and live performances. LED WAH On/Off Indicator: A red LED located above the WAH switch serves as on on/off indicator. [. . . ]