User manual MORLEY PEDALS BSP1

[. . . ] Turning the tone control left from 12 o'clock (mid) position will boost the lows and reduce the highs; turning the control right from mid position boosts the highs and slightly reduces the lows. COMBINATIONS: You can use the BSP1 for the following combinations of effects: - Volume only - WAH only - Distortion only - Distortion with volume control - Distortion with WAH To prolong battery life, unplug your cord completely from the input jack when not using the pedal. When the pedal is not used for extended periods, we recommend you remove the battery from the pedal or replace it every six months to prevent leakage problems. BATTERY REPLACEMENT When the battery becomes weak, the overall wah and distortion effects will become weak. [. . . ] Remove the battery door located on the bottom of the pedal (a short cord is attached to the door to help prevent loss). Once the door is off, the old battery can be removed from the battery snap and a new battery plugged in. Make sure the polarity (+/-) is correct before inserting the new battery. When you replace the battery door , you will notice it fits very tightly against the battery. This prevents the battery from rattling inside the pedal. OPERATION VOLUME MODE: The pedal will be in volume mode when both the LED above the WAH switch and the LED above the Distortion switch are off. The Volume mode has been specifically designed for gradual volume increases as the pedal is moved from "off" (toe-up) to "mid-travel" (halfway between toe up and toe down). From "mid-travel" to "full on" (toe down) the volume increases faster. Make sure the cords are completely plugged in for best results. WARRANTY All Morley® pedals are warranted for two years from date of purchase. To obtain warranty service contact the store where purchased, or call 1-800-639-4668. NOTES: 1. Using the BSP1 distortion mode at maximum setting when your amp is in distortion or high gain may cause uncontrolled feedback or a high pitched squeal. . When using the Drive and Level controls at maximum settings, some cross-talk may occur in volume mode. If the TONE control is set to full when using both the Wah and distortion modes, the overall sound will be particularly bright and brittle. AC ADAPTER Use Morley's 9VDC 300 milliamp regulated adapter only. Using a non-regulated adapter could cause a low frequency hum in your amplifier and may damage the pedal. SPECIFICATIONS POWER: 9 Volt Battery or Morley's 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 15 mA @ 9 VDC WEIGHT: 3. 1 lb. / 1. 36 kg INDICATOR: Wah mode; Wah LED on Distortion mode; Distortion LED on Volume mode; Both LED's off BATTERY The BSP1 is designed to use one 9 volt battery when not using an adapter. We suggest you use a good quality alkaline battery. FEATURES · LED indication: Located above the "WAH" and "Distortion" switches. [. . . ] Using a non-regulated adapter could cause a low frequency hum in your amplifier and may damage the pedal. SPECIFICATIONS POWER: 9 Volt Battery or Morley's 9VDC 300 milliamp regulated adapter (center pin is negative) CURRENT DRAW: 15 mA @ 9 VDC WEIGHT: 3. 1 lb. / 1. 36 kg INDICATOR: Wah mode; Wah LED on Distortion mode; Distortion LED on Volume mode; Both LED's off BATTERY The BSP1 is designed to use one 9 volt battery when not using an adapter. We suggest you use a good quality alkaline battery. FEATURES · LED indication: Located above the "WAH" and "Distortion" switches. Indicate when pedal is in wah or distortion mode. [. . . ]